Subaru Crosstrek Owners Manual: Using the jack
1. Park on a hard, level surface, whenever possible, then stop the engine.
2. Apply the parking brake securely and shift the shift lever in reverse (MT models) or the select lever to the "P" (Park) position (CVT models).
3. Turn on the hazard warning flasher and unload all occupants and luggage from the vehicle.
4. Put wheel blocks at the front and rear of the tire diagonally opposite the tire that you are going to replace.
5. Take out the jack and jack handle.
Jack-up points
6. Place the jack under the side sill at the front or rear jack-up point closest to the tire that you are going to replace.
Turn the jackscrew by hand until the jack head engages firmly into the jack-up point.
7. Insert the jack handle into the jackscrew, and turn the handle until the tire clears the ground. Do not raise the vehicle higher than necessary.
Tool locations
Jack handle
Tool bucket
Spare tire
Wheel nut wrench
Screwdriver
Jack
Towing hook (eye bolt)
A jack handle is stored under the floor of
the cargo area. A jack and a towin ...
Flat tires
If you have a flat tire while driving, never
brake suddenly; keep driving straight
ahead while gradually reducing speed.
Then slowly pull off the road to a safe
place. ...
Other materials:
Dome light and cargo area light
Dome light
Cargo area light
1. Remove the lens by prying the edge of
the lens with a flat-head screwdriver.
2. Pull the bulb out of the socket.
3. Install a new bulb.
4. Reinstall the lens.
Other bulbs
It may be difficult to replace the bulbs.
Have the bulbs replaced by your
...
Security indicator light
This indicator light shows the status of the
alarm system. It also indicates operation
of the immobilizer system.
Alarm system
It blinks to show the driver the operational
status of the alarm system. For detailed
information, refer to "Alarm system"
Immobilizer system
The security indicator ...
Removal
EXHAUST(H4DO) > Front Exhaust PipeREMOVALCAUTION:Vehicle components are extremely hot after driving. Be wary of receiving burns from heated parts.1. Disconnect the ground cable from battery. NOTE">2. Lift up the vehicle.3. Remove the under cover. Front Under Cover > REMOVAL"> ...
