Subaru Crosstrek Owners Manual: Type C and D
1. Depress the "AUTO" button. The indicator light "FULL AUTO" on the display illuminates.
2. Set the preferred temperature using the temperature control dial.
NOTE
- The controllable temperature range may vary depending on the regional specifications of the vehicle.
- If you operate any of the buttons on
the control panel other than the "OFF"
button, rear window defogger button
and temperature control dial(s) during
FULL AUTO mode operation, the
"FULL" indicator light on the control
panel will turn off and the "AUTO"
indicator light will remain illuminated.
You can then manually control the system as desired using the button you operated. To change the system back to the FULL AUTO mode, press the "AUTO" button.
To turn off the climate control system, press the "OFF" button. Then the air inlet selection will be set to OFF (outside air).
Operation tips
- Operate the automatic climate control system when the engine is running.
- Even when cooling is not necessary, the air conditioner compressor will automatically turn on if the temperature is set much lower than the current outlet air temperature. Even in this case, the "A/C" indicator light on the control panel illuminates.
Type B
1. Turn the airflow mode selection dial
and fan speed control dial to the "AUTO"
position.
2. Set the preferred temperature using
the temperature control dial.
NOTE
Each function can be ind ...
Sensors
Interior air temperature sensor
Solar sensor
The automatic climate control system
employs several sensors. These sensors
are delicate. If they are not treated
properly and become damage ...
Other materials:
Turn signal lever
To activate the right turn signal, push the
turn signal lever up. To activate the left
turn signal, push the turn signal lever
down. When the turn is finished, the lever
will return automatically. If the lever does
not return after cornering, return the lever
to the neutral position by han ...
Removal
EyeSight > Stereo CameraREMOVALCAUTION:• When the stereo camera or windshield glass has been replaced, removed or installed, always perform the adjustment and inspection of the camera. (When the stereo camera has been replaced with a new part, the camera remains in a failed state until adju ...
Dtc b1906 open in front p/t lh
AIRBAG SYSTEM (DIAGNOSTICS) > Diagnostic Chart with Trouble CodeDTC B1906 OPEN IN FRONT P/T LHDiagnosis start condition:Ignition voltage is 10 V to 16 V.DTC detecting condition:• Seat belt pretensioner (LH) circuit is open.• Pretensioner (LH) is faulty.• Pretensioner harness (LH ...
