Subaru Crosstrek Owners Manual: Turn off display of driving information display
The driving information display can be turned off.
To turn off the display, turn the ignition switch to the "LOCK"/"OFF" position and press the "+" button adjacent to the clock display for approximately 5 seconds.
Then, the driving information display and the clock display will blink for 3 seconds to notify you that the driving information display has been turned off.
To restore the driving information display, once again press the "+" button for approximately 5 seconds.
NOTE
- The initial display setting of the driving information display has been set to operational at the time of shipment from the factory.
- The average fuel consumption and average vehicle speed are calculated even while the driving information display is not displayed.
- Even if you turn off the driving information display, the display will automatically turn on when the battery voltage is disconnected and then reconnected for battery replacement or fuse replacement.
Average vehicle speed
U.S.-spec. models
Except U.S.-spec. models
This display shows the average vehicle
speed since the trip meter was last reset.
Trip knob
Pressing the trip knob toggles the displa ...
Clock
To adjust the time shown by the clock,
press the "+" button or "−" button. If you
press the "+" button, the indicated time will
change in one-minute increments. If you
press the "− ...
Other materials:
Removal
LIGHTING SYSTEM > Door SwitchREMOVAL1. Disconnect the ground cable from battery. NOTE">2. Remove the switch assembly - door.(1) Remove the screws, and pull out the switch assembly - door toward you.(2) Disconnect the connector and remove the switch assembly - door. ...
Dtc u0122 lost communication with vehicle dynamics control module
HVAC SYSTEM (AUTO A/C) (DIAGNOSTICS) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC U0122 LOST COMMUNICATION WITH VEHICLE DYNAMICS CONTROL MODULEDetected when CAN data from VDC does not arrive.NOTE:Perform the diagnosis for LAN system. Basic Diagnostic Procedure > PROCEDURE" ...
Dtc p1532 battery charging system
ENGINE (DIAGNOSTICS)(H4DO) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC P1532 BATTERY CHARGING SYSTEMDTC detecting condition:Immediately at fault recognitionCAUTION:After servicing or replacing faulty parts, perform Clear Memory Mode Clear Memory Mode > OPERATION">, an ...
