1. Perform the preparation steps according to "Preparation for screen settings"
2. Operate the " " or " " switch to select the "Triple Meter" item. Then push the button.
3. Select the setting location (left, center or right) by operating the " " or " " switch. Then push the button.
NOTE
The same item cannot be selected for the left, center or right location.
4. Select the preferred item by operating the " " or " " switch. Then push the button.
If you also want to change the setting for another location, repeat steps 3 and 4.
5. Select "Set" by operating the " "switch, and confirm the setting by pushing the button.
6. The system will notify you that the setting is complete.
Installation
EXTERIOR BODY PANELS > Rear GateINSTALLATION1. REAR GATE PANELCAUTION:The panel - rear gate is heavy. When removing and installing it, always work in a team of two or more persons.1. Install the hinge - rear gate to the vehicle body.2. Temporarily install the panel - rear gate to the hinge - rear ...
Dtc c0044 tcm communication circuit
VEHICLE DYNAMICS CONTROL (VDC) (DIAGNOSTICS) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC C0044 TCM COMMUNICATION CIRCUITDTC detecting condition:No CAN signal from TCM.Trouble symptom:• ABS does not operate.• VDC does not operate.• EyeSight does not operate.STEPC ...
Specifications
Dimensions
These specifications are subject to change without notice.
*: Measured with vehicle empty
Engine
Fuel
For more details, refer to "Fuel" F7-3. ...