Subaru Crosstrek Service Manual: Transfer clutch

Installation

CONTINUOUSLY VARIABLE TRANSMISSION(TR580) > Torque Converter AssemblyINSTALLATION1. Install the O-ring to the input shaft.NOTE:• Use new O-rings.• Apply CVTF to the O-ring.2. While hold ...

Adjustment

CONTINUOUSLY VARIABLE TRANSMISSION(TR580) > Transfer ClutchADJUSTMENT1. Install the transfer clutch assembly to the extension case with the transfer driven gear shims and thrust bearings removed.2. ...

Other materials:

State emission testing (U.S. only)
WARNING Testing of an All-Wheel Drive model must NEVER be performed on a single two-wheel dynamometer. Attempting to do so will result in uncontrolled vehicle movement and may cause an accident or injuries to persons nearby. CAUTION At state inspection time, remember to tell your inspe ...

Hill start assist warning light does not come on
VEHICLE DYNAMICS CONTROL (VDC) (DIAGNOSTICS) > Warning Light Illumination PatternHILL START ASSIST WARNING LIGHT DOES NOT COME ONDetecting condition:Defective combination meterTrouble symptom:When the ignition switch is turned to ON (engine OFF), hill start assist warning light does not illuminat ...

Installation
LIGHTING SYSTEM > Front Fog Light BulbINSTALLATIONCAUTION:• After connecting the connector, make sure that the bulb is locked securely.• Install the mud guard - front so that the front end of the mud guard (b) comes outside the bumper face - front (a).Install each part in the reverse ...