Subaru Crosstrek Owners Manual: Trailer towing tips
CAUTION
- For models equipped with the BSD (Blind Spot Detection) and RCTA (Rear Cross Traffic Alert) driving support systems, when towing a trailer, press the BSD/ RCTA OFF switch to deactivate the system. The system may not operate properly due to the blocked radar waves. For details about the BSD/RCTA OFF switch, refer to "BSD/RCTA OFF switch" F7-55.
- Never exceed 45 mph (72 km/h) when towing a trailer in hilly country on hot days.
- When towing a trailer, steering, stability, stopping distance and braking performance will be different when compared to normal operation. For safety's sake, you should employ extra caution when towing a trailer and you should never drive at excessive speeds. You should also keep the following tips in mind:
- When parking on a steep slope with a trailer attached to your vehicle, the braking power of the parking brake may not be sufficient since stronger braking power is needed.
Tires
WARNING
Never tow a trailer when the temporary
spare tire is used. The temporary
spare tire is not designed to
sustain the towing load. Use of the
temporary spare tire when towing
can result in ...
Before starting out on a trip
Check the towing regulations for trailer
or caravan vehicles that vary by state/
region. Failure to comply with the procedures
set forth will not only compromise
your safety, but will also ...
Other materials:
Dtc c1232 rear right abs sensor signal
VEHICLE DYNAMICS CONTROL (VDC) (DIAGNOSTICS) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC C1232 REAR RIGHT ABS SENSOR SIGNALNOTE:For the diagnostic procedure, refer to “DTC C1242 REAR LEFT ABS SENSOR SIGNAL”. Diagnostic Procedure with Diagnostic Trouble Code (DTC) > ...
Inspection
LUBRICATION(H4DO) > Oil Pressure SystemINSPECTIONSTEPCHECKYESNO1.CHECK ENGINE OIL AMOUNT.Is the engine oil amount normal? Engine Oil > INSPECTION"> Oil Pressure System > INSPECTION">Go to Step 2.Adjust the engine oil amount. Engine Oil > INSPECTION"> After the o ...
Adjustment
MANUAL TRANSMISSION AND DIFFERENTIAL(5MT) > Reverse Idler GearADJUSTMENT1. Select the appropriate reverse shifter lever from the table below, and adjust until the clearance between the reverse idler gear and transmission case wall is within specification.Clearance A:6.0 — 7.5 mm (0.236 — 0.29 ...
