Subaru Crosstrek manuals

Subaru Crosstrek Owners Manual: To set cruise control

Cruise control main button
Cruise control main button

1. Press the cruise control main button.

Cruise control indicator light (type A)
Cruise control indicator light (type A)

Cruise control indicator light (type B)
Cruise control indicator light (type B)

The cruise control indicator light on the combination meter will illuminate.

2. Depress the accelerator pedal until the vehicle reaches the desired speed.

To set cruise control

3. Press the "RES/SET" switch to the "SET" side and release it. Then release the accelerator pedal.

Cruise control set indicator light (type A)
Cruise control set indicator light (type A)

Cruise control set indicator light (type B)
Cruise control set indicator light (type B)

At this time, the cruise control set indicator light is illuminated in the combination meter.

The vehicle will maintain the desired speed.

Vehicle speed can be temporarily increased while driving with the cruise control activated. Simply depress the accelerator pedal to accelerate the vehicle.

When the accelerator pedal is released, the vehicle will return to and maintain the previous cruising speed.

Cruise control (if equipped)
NOTE For models with EyeSight system: Refer to the Owner's Manual supplement for the EyeSight system. Cruise control enables you to maintain a constant vehicle speed without holding your foot on ...

To temporarily cancel the cruise control
The cruise control can be temporarily canceled in the following ways. Press the "CANCEL" button. Depress the brake pedal. Depress the clutch pedal (MT models only). WARNING For CVT mo ...

Other materials:

Battery drainage prevention function
If a door or the rear gate is not completely closed, the interior lights will remain illuminated as a result. However, several lights are automatically turned off by the battery drainage prevention function to prevent the battery from discharging. The following interior lights are affected by ...

Inspection
LIGHTING SYSTEM > Door SwitchINSPECTION1. Check the resistance between switch terminals.Preparation tool:Circuit testerTerminal No.Inspection conditionsStandardConnection diagram1 — 3When door is openedLess than 1 ?When door is closed1 M? or more2. Replace the switch assembly - door if the insp ...

Brake booster
If the brake booster does not operate as described in the following, have it checked by your SUBARU dealer. 1. With the ignition switch in the "LOCK"/ "OFF" position, depress the brake pedal several times, applying the same pedal force each time. The distance the pedal travels should not va ...

© 2016-2022 Copyright www.sucross.com