Subaru Crosstrek Owners Manual: To hook the top tether
CAUTION
- Except for the center seating position, remove the head restraint when mounting a child restraint system. Otherwise, it might be possible that the top tether cannot be fastened tightly.
- For the center seating position,
raise the center head restraint to
the extended position when
mounting a child restraint system.
Otherwise, it will be impossible to use the seatbelt guide that is attached to the head restraint correctly.
The seatbelt guide is essential for routing the belt webbing at the center seating position. For information about using the seatbelt guide, refer to "Rear center seatbelt" 1-16.
1. Attach the top tether hook to the appropriate upper anchorage.
For the center seating position, route the top tether under the head restraint as illustrated below.
- Seatbelt guide
- Seatbelt of the center seating position
- Top tether
2. Tighten the top tether securely.
Please contact your SUBARU dealer if you have any question regarding the installation of a child restraint system.
Anchorage location
For left seat
For center seat
For right seat
Three upper anchorages are installed on
the back side of the rear seatback. ...
SRS airbag (Supplemental Restraint System airbag)
*SRS: This stands for supplemental restraint
system. This name is used because
the airbag system supplements the
vehicle's seatbelts.
Your vehicle is equipped with a supplemental
restraint syst ...
Other materials:
Driving on grades
Before going down a steep hill, slow
down and shift into lower gear (if necessary,
use 1st gear) in order to utilize the
engine braking effect and prevent overheating
of your vehicle's brakes. Do not
make sudden downshifts.
When driving uphill in hot weather, the
air conditioner may ...
Inspection
FUEL INJECTION (FUEL SYSTEMS)(H4DO) > Camshaft Position SensorINSPECTION1. CAMSHAFT POSITION SENSOR (METHOD WITH OSCILLOSCOPE)1. Prepare an oscilloscope.2. Remove the glove box. Glove Box > REMOVAL">3. Connect the probe to ECM connector.• Intake camshaft position sensor• E ...
Inspection
MECHANICAL(H4DO) > V-beltINSPECTION1. Check the V-belt for cracks, tear or wear.2. Check the V-belt tensioner assembly and idler pulley for deformation, cracks or other damages.3. Check that the V-belt ribs are securely placed on the rib grooves for each pulley.4. Check that the V-belt tensioner ...
