Subaru Crosstrek Owners Manual: To decrease the speed (by brake pedal)
1. Depress the brake pedal to release cruise control temporarily.
2. When the speed decreases to the desired speed, press the "RES/SET" switch to the "SET" side once. Now the desired speed is set and the vehicle will keep running at that speed without depressing the accelerator pedal.
Cruise control indicator light
Refer to "Cruise control indicator light" F3-31.
Cruise control set indicator light
Refer to "Cruise control set indicator light" F3-31.
To decrease the speed (by the "RES/SET" switch)
Press the "RES/SET" switch to the "SET"
side and hold it until the vehicle reaches
the desired speed. Then, release the
switch. The vehicle speed at that moment
will be memorized and treated a ...
BSD/RCTA (if equipped)
The BSD/RCTA consists of rear radar with
Blind Spot Detection and Rear Cross
Traffic Alert.
These functions enable the system to
detect objects or vehicles to the rear,
drawing attention to the ...
Other materials:
Inspection
CLUTCH SYSTEM > Clutch SwitchINSPECTION1. CLUTCH START SWITCH1. Perform the following inspections. If the clutch start switch does not operate normally, adjust the switch, and check it again. Clutch Switch > ADJUSTMENT">• Make sure that engine does not start with clutch pedal no ...
Dtc p0304 cylinder 4 misfire detected
ENGINE (DIAGNOSTICS)(H4DO) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC P0304 CYLINDER 4 MISFIRE DETECTEDDTC detecting condition:• Detected when two consecutive driving cycles with fault occur.• Immediately at fault recognition (A misfire which could damage catalyst oc ...
Dtc b2789 id code box communication
KEYLESS ACCESS WITH PUSH BUTTON START SYSTEM (DIAGNOSTICS) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC B2789 ID CODE BOX COMMUNICATIONDTC detecting condition:• When communication between keyless access CM and ID code box is interrupted for a set amount of time.• Open ...
