Subaru Crosstrek Owners Manual: To arm the system using the keyless access function (if equipped)
1. Close all windows and the moonroof (if equipped) 2. Turn the push-button ignition switch to the "OFF" position.
3. Open the doors and get out of the vehicle.
4. Make sure that the engine hood is locked.
5. Close all doors and the rear gate.
- Door lock sensor
Security indicator light (type A)
Security indicator light (type B)
6. Carry the access key and touch the door lock sensor. All doors (including the rear gate) will lock, an electronic chirp will sound once, the hazard warning flashers will flash once, and the security indicator light will start flashing rapidly. After rapid flashing for 30 seconds (standby time), the security indicator light will then flash slowly (twice approximately every 2 seconds), indicating that the system has been armed for surveillance.
If any of the doors or the rear gate is not fully closed, an electronic chirp sounds five times, the hazard warning flashers flash five times to alert you that the doors (or the rear gate) are not properly closed.
When you close the door, the system will automatically arm and doors will automatically lock.
To arm the system using power door locking switches
1. Close all windows.
2. Remove the key from the ignition
switch (models without "keyless access
with push-button start system")/turn the
push-button ignition switch to the "OFF"
position (mode ...
Disarming the system
Perform either of the following procedures.
Briefly press the disarm button (for less
than 2 seconds) on the access key/remote
transmitter.
Carry the access key and perform
either of the followin ...
Other materials:
Gross Axle Weight (GAW) and Gross Axle Weight Rating (GAWR)
Gross Axle Weight
The total weight applied to each axle
(GAW) must never exceed the Gross Axle
Weight Rating (GAWR). The front and rear
GAWs can be adjusted by relocating
passengers and luggage inside the vehicle.
The front and rear GAWR of your
vehicle that is given by SUBARU are also
...
BT Devices Connection screen
1. Press the HOME button.
2. Touch the "SETTINGS" key and then
touch the tab.
3. Touch the "BT Devices Connection"
key and then select the desired device to
register.
"BT Devices Connection" screen (One device is registered.)
Register the device. Refer to "Registering/
connecting ...
Electrical component location Location
ENGINE (DIAGNOSTICS)(H4DO) > Electrical Component LocationLOCATION1. CONTROL MODULE(1)Engine control module (ECM)(3)Malfunction indicator light(4)Data link connector(2)Delivery (test) mode fuse 2. SENSOR(1)Mass air flow and intake air temperature sensor(5)Crankshaft position sensor(9)Intake ca ...
