Subaru Crosstrek manuals

Subaru Crosstrek Owners Manual: Tire replacement

The wheels and tires are important and integral parts of your vehicle's design; they cannot be changed arbitrarily. The tires fitted as standard equipment are optimally matched to the characteristics of the vehicle and were selected to give the best possible combination of running performance, ride comfort, and service life. It is essential for every tire to have a size and construction matching those shown on the tire placard and to have a speed symbol and load index matching those shown on the tire placard.

Using tires of a non-specified size detracts from controllability, ride comfort, braking performance, speedometer accuracy and odometer accuracy. It also creates incorrect body-to-tire clearances and inappropriately changes the vehicle's ground clearance.

All four tires must be the same in terms of manufacturer, brand (tread pattern), construction, and size. You are advised to replace the tires with new ones that are identical to those fitted as standard equipment.

For safe vehicle operation, SUBARU recommends replacing all four tires at the same time.

WARNING

When replacing or installing tire (s), all four tires must be the same for following items.

a) Size

(b) Circumference

(c) Speed symbol

(d) Load index

(e) Construction

(f) Manufacturer

(g) Brand (tread pattern)

(h) Degrees of wear

For the items (a) to (d), you must obey the specification that is printed on the tire placard. The tire placard is located on the driver's door pillar.

If all of four tires are not the same for items (a) to (h), serious mechanical damage could occur to the drive train of your car, and affect the following.

It also may be dangerous and lead to loss of vehicle control, and it can lead to an accident.

Use only radial tires. Do not use radial tires together with belted bias tires and/or bias-ply tires.

Doing so can dangerously reduce controllability, resulting in an accident.

Tire rotation
Vehicles equipped with 4 non-unidirectional tires Front Vehicles equipped with unidirectional tires Front Tire wear varies from wheel to wheel. Move the tires to the positions ...

Wheel replacement
When replacing wheels due, for example, to damage, make sure the replacement wheels match the specifications of the wheels that are fitted as standard equipment. Replacement wheels are available ...

Other materials:

Inspection
SECURITY AND LOCKS > Rear Gate Latch and Actuator AssemblyINSPECTION1. LATCHCheck if the latch operates normally.If latch deformation, abnormal wear, or unsmooth lock operation is observed, replace the latch and actuator - rear gate.2. ACTUATORPreparation tool:Circuit tester1. Check door lock ope ...

Inspection
VEHICLE DYNAMICS CONTROL (VDC) (DIAGNOSTICS) > Warning Light Illumination PatternINSPECTION(1)Ignition switch(6)Light OFF(11)2 seconds or more(2)OFF(7)Light ON(12)Brake warning light (EBD warning light)(3)ON(8)2 seconds(13)Parking brake(4)Engine start(9)VDC OFF indicator light(14)Released(5)ABS w ...

Dtc p0951 auto shift manual control circuit range/performance
CONTINUOUSLY VARIABLE TRANSMISSION (DIAGNOSTICS) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC P0951 AUTO SHIFT MANUAL CONTROL CIRCUIT RANGE/PERFORMANCEDTC detecting condition:Immediately at fault recognitionTrouble symptom:Manual mode can not be set.CAUTION:Use the check board whe ...

© 2016-2024 Copyright www.sucross.com