TIRE PRESSURE MONITORING SYSTEM (DIAGNOSTICS) > Tire Pressure Warning Light / Trouble Indicator Light Illumination Pattern
TIRE PRESSURE WARNING LIGHT IS 25 TIMES BLINKING AND TURN ON
Detecting condition:
• Defective TPMS & keyless entry CM or TPMS CM
• Defective harness
• Transmitter is faulty.
Trouble symptom:
Every time the engine starts, tire pressure warning light blinks 25 times and then illuminates.
Wiring diagram:
Tire Pressure Monitoring System Tire Pressure Monitoring System > WIRING DIAGRAM">
STEP | CHECK | YES | NO |
1.CHECK DTC.
Connect the Subaru Select Monitor, and read the Diagnostic Trouble Code. Read Diagnostic Trouble Code (DTC) > OPERATION">
Is diagnostics code (DTC) displayed?
Perform the diagnosis according to the DTC. List of Diagnostic Trouble Code (DTC)">
Tire Pressure Warning Light / Trouble Indicator Light Illumination Pattern > TIRE PRESSURE WARNING LIGHT IS 25 TIMES BLINKING AND TURN ON">Go to Step 2.
2.CHECK LAN COMMUNICATION.
Inspect LAN system. Basic Diagnostic Procedure > PROCEDURE">
Is there any fault?
Repair it according to the diagnosis for LAN system.
Tire Pressure Warning Light / Trouble Indicator Light Illumination Pattern > TIRE PRESSURE WARNING LIGHT IS 25 TIMES BLINKING AND TURN ON">Go to Step 3.
3.CHECK HARNESS.
Measure the resistance between TPMS & keyless entry CM or TPMS CM and body integrated unit.
Connector & terminal
Without keyless access with push button start
(R221) No. 11 — (i171) No. 11:
With keyless access with push button start
(R211) No. 11 — (i171) No. 11:
Is the resistance less than 10 ??
Tire Pressure Warning Light / Trouble Indicator Light Illumination Pattern > TIRE PRESSURE WARNING LIGHT IS 25 TIMES BLINKING AND TURN ON">Go to Step 4.
Repair the harness.
4.CHECK CONNECTOR.
Check each connector.
Is there poor contact or any other faults?
Repair the connector.
Replace the TPMS & keyless entry CM or TPMS CM. Tire Pressure Monitoring System">
Disassembly
DRIVE SHAFT SYSTEM > Rear Drive ShaftDISASSEMBLY1. Remove the outer race (DOJ) from the shaft assembly.CAUTION:Be careful not to damage the boot.(1) Using a flat tip screwdriver or pliers, loosen the boot band on the large end of boot (DOJ).CAUTION:Be careful not to damage the boot.(2) Remove the ...
Valet mode
When you choose the valet mode, the
alarm system does not operate. In valet
mode, the remote transmitter is used only
for locking and unlocking the doors and
rear gate and panic activation.
To enter the valet mode, change the
setting of your vehicle's alarm system for
deactivation mode. Ref ...
Driver's seatbelt
The driver's seatbelt has a shoulder belt
pretensioner.
The pretensioner sensor also serves as
follows.
SRS frontal airbag sensor
Side impact sensor
Front door impact sensor
Rollover sensor
If the sensor detects a certain predetermined
amount of force during frontal or
side col ...