Subaru Crosstrek Service Manual: Tire pressure warning light does not come on
TIRE PRESSURE MONITORING SYSTEM (DIAGNOSTICS) > Tire Pressure Warning Light / Trouble Indicator Light Illumination Pattern
TIRE PRESSURE WARNING LIGHT DOES NOT COME ON
DETECTING CONDITION:
Defective combination meter
TROUBLE SYMPTOM:
When the ignition switch is turned to ON, the tire pressure warning light does not turn on (for approx. 2 seconds).
| STEP | CHECK | YES | NO |
1.CHECK DIAGNOSTIC TROUBLE CODE (DTC).
Connect the Subaru Select Monitor, and read the Diagnostic Trouble Code. Read Diagnostic Trouble Code (DTC) > OPERATION">
Is diagnostics code (DTC) displayed?
Perform the diagnosis according to the DTC. List of Diagnostic Trouble Code (DTC)">
Replace the combination meter. Combination Meter > REMOVAL">
Tire pressure warning light is 25 times blinking and turn on
TIRE PRESSURE MONITORING SYSTEM (DIAGNOSTICS) > Tire Pressure Warning Light / Trouble Indicator Light Illumination PatternTIRE PRESSURE WARNING LIGHT IS 25 TIMES BLINKING AND TURN ONDetecting condi ...
Tire pressure warning light does not come off
TIRE PRESSURE MONITORING SYSTEM (DIAGNOSTICS) > Tire Pressure Warning Light / Trouble Indicator Light Illumination PatternTIRE PRESSURE WARNING LIGHT DOES NOT COME OFFDETECTING CONDITION:• De ...
Other materials:
Adjustment
POWER ASSISTED SYSTEM (POWER STEERING) > Electric Power Steering GearboxADJUSTMENT1. GEARBOX BACKLASH ADJUSTMENT1. Remove the steering gearbox assembly. Electric Power Steering Gearbox > REMOVAL">2. Loosen the lock nut and adjusting screw.3. Apply a coat of grease to the sliding surfa ...
Dtc p0014 "b" camshaft position - timing over-advanced or system performance bank 1
ENGINE (DIAGNOSTICS)(H4DO) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC P0014 "B" CAMSHAFT POSITION - TIMING OVER-ADVANCED OR SYSTEM PERFORMANCE BANK 1DTC detecting condition:Detected when two consecutive driving cycles with fault occur.Trouble symptom:• Engine sta ...
Inspection
POWER ASSISTED SYSTEM (POWER STEERING) > Steering ColumnINSPECTION1. UNIT INSPECTIONCheck the following items, and if there is anything out of standard value, it is considered to be damaged. If so, replace it with a new part.• Measure the whole length of the column assembly - steering.Stand ...
