Subaru Crosstrek Owners Manual: Tire pressure monitoring system (TPMS) (U.S.-spec. models)
Low tire pressure warning light (type A)
Low tire pressure warning light (type B)
The tire pressure monitoring system provides the driver with the warning message indicated by sending a signal from a sensor that is installed in each wheel when tire pressure is severely low.
The tire pressure monitoring system will activate only when the vehicle is driven.
Also, this system may not react immediately to a sudden drop in tire pressure (for example, a blow-out caused running over a sharp object).
WARNING
If the low tire pressure warning light illuminates while driving, never brake suddenly. Instead, perform the following procedure.
Otherwise an accident involving serious vehicle damage and serious personal injury could occur.
(1) Keep driving straight ahead while gradually reducing speed.
(2) Slowly pull off the road to a safe place.
(3) Check the pressure for all four tires and adjust the pressure to the COLD tire pressure shown on the vehicle placard on the door pillar on the driver's side.
If this light still illuminates while driving after adjusting the tire pressure, a tire may have significant damage and a fast leak that causes the tire to lose air rapidly.
If you have a flat tire, replace it with a spare tire as soon as possible.
- When a spare tire is mounted or a
wheel rim is replaced without the
original pressure sensor/transmitter
being transferred, the low
tire pressure warning light will
illuminate steadily after blinking
for approximately one minute.
This indicates the TPMS is unable to monitor all four road wheels. Contact your SUBARU dealer as soon as possible for tire and sensor replacement and/ or system resetting.
- When a tire is repaired with liquid
sealant, the tire pressure warning
valve and transmitter may not
operate properly. If a liquid sealant
is used, contact your nearest
SUBARU dealer or other qualified
service shop as soon as possible.
Make sure to replace the tire pressure warning valve and transmitter when replacing the tire. You may reuse the wheel if there is no damage to it and if the sealant residue is properly cleaned off.
If the light illuminates steadily after blinking for approximately one minute, promptly contact a SUBARU dealer to have the system inspected.
Changing a flat tire
WARNING
Do not jack up the vehicle on an
incline or a loose road surface.
The jack can come out of the
jacking point or sink into the
ground and this can result in a
severe accident.
...
Jump starting
WARNING
Battery fluid is SULFURIC ACID.
Do not let it come in contact with
the eyes, skin, clothing or the
vehicle.
If battery fluid gets on you,
thoroughly flush the exposed
area ...
Other materials:
Installation
BRAKE > Brake BoosterINSTALLATION1. Check and adjust the operating rod of the vacuum booster assembly.(1) Measure the length between the vacuum booster assembly mounting surface and clevis pin hole.(2) If it is not within the specification, loosen the lock nut, rotate the vacuum booster assembly ...
Update contacts from phone
Operation methods differ between PBAP
(Phone Book Access Profile) compatible
and PBAP incompatible but OPP (Object
Push Profile) compatible Bluetooth
phones.
1. Display the "PHONE" screen. Refer to
"How to change the hands-free phone system" F5-73.
2. Touch the "Contacts" key, and then
s ...
Engine overheating
WARNING
Never remove the radiator cap of your Subaru Ascent until the engine has been
completely switched off and allowed to cool down fully. When the engine is hot,
the cooling system remains under high pressure.
Opening the cap prematurely may cause a sudden release of pressurized, boiling ...
