When a tire's tread wear indicator becomes visible, the tire is worn beyond the acceptable limit and must be replaced immediately.
With a tire in this condition, driving at even low speeds in wet weather can cause the vehicle to hydroplane.
Possible resulting loss of vehicle control can lead to an accident.
For information about the tire rotation order, refer to "Tire rotation" F11-26. Replace any damaged or unevenly worn tires at the time of rotation. After tire rotation, adjust the tire pressures and make sure the wheel nuts are correctly tightened.
For information about the tightening torque and tightening sequence for the wheel nuts, refer to "Flat tires" F9-5.
Preparation tool
IMMOBILIZER (DIAGNOSTICS) > General DescriptionPREPARATION TOOL1. SPECIAL TOOLILLUSTRATIONTOOL NUMBERDESCRIPTIONREMARKS — SUBARU SELECT MONITOR 4Used for setting of each function and troubleshooting for electrical system.NOTE:For detailed operation procedures of Subaru Select Monitor 4, refer t ...
Dtc p0967 pressure control solenoid "b" control circuit high
CONTINUOUSLY VARIABLE TRANSMISSION (DIAGNOSTICS) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC P0967 PRESSURE CONTROL SOLENOID "B" CONTROL CIRCUIT HIGHDTC detecting condition:Immediately at fault recognitionTrouble symptom:Engine speed increases abruptly, and can not star ...
Removal
SECURITY AND LOCKS > Immobilizer AntennaREMOVAL1. MODEL WITHOUT KEYLESS ACCESS WITH PUSH BUTTON START1. Disconnect the ground cable from battery. NOTE">2. Remove the cover assembly - column.(1) Remove the screws by turning the steering wheel to right and left.(2) Release the claw, and re ...