
The tilting function is activated only when the moonroof is fully closed.
To raise: Press the rear side of the "UP/DOWN" switch momentarily. The moonroof raises completely.
To lower: Press and hold the front side of the "UP/ DOWN" switch until the preferred position has reached.
Release the switch after the moonroof has been raised or has been lowered completely.
Pressing the switch continuously may cause damage to the moonroof.
Sliding moonroofDtc p0031 a/f / o2 heater control circuit low bank 1 sensor 1
ENGINE (DIAGNOSTICS)(H4DO) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC P0031 A/F / O2 HEATER CONTROL CIRCUIT LOW BANK 1 SENSOR 1DTC DETECTING CONDITION:Immediately at fault recognitionCAUTION:After servicing or replacing faulty parts, perform Clear Memory Mode Clear Memory Mode ...
Removal
EXTERIOR/INTERIOR TRIM > Side GarnishREMOVAL1. Remove the clips and detach the side garnish assembly.(1)Garnish ASSY - fender(2)Garnish ASSY - rear quarter(3)Garnish ASSY - side sill2. Remove the garnish assembly or protector on the fender panel.CAUTION:Do not reuse the garnish assembly and prote ...
Removal
LIGHTING SYSTEM > Rear Combination Light AssemblyREMOVAL1. CROSSTREK MODEL1. Disconnect the ground cable from battery. NOTE">2. Remove the light assembly - rear combination.CAUTION:Be careful not to damage the clips.(1) Release the bolts and clips, then pull out the light assembly - rear ...