Subaru Crosstrek manuals

Subaru Crosstrek Owners Manual: Temperature A, B, C

The temperature grades are A (the highest), B, and C, representing the tire's resistance to the generation of heat and its ability to dissipate heat when tested under controlled conditions on a specified indoor laboratory test wheel. Sustained high temperature can cause the material of the tire to degenerate and reduce tire life, and excessive temperature can lead to sudden tire failure. The grade C corresponds to a level of performance which all passenger car tires must meet under the Federal Motor Vehicle Safety Standards No. 109. Grades B and A represent higher levels of performance on the laboratory test wheel than the minimum required by law.

WARNING

The temperature grade for this tire is established for a tire that is properly inflated and not overloaded. Excessive speed, underinflation, or excessive loading, either separately or in combination, can cause heat buildup and possible tire failure.

Traction AA, A, B, C
The traction grades, from highest to lowest, are AA, A, B and C. Those grades represent the tire's ability to stop on wet pavement as measured under controlled conditions on specified government ...

Reporting safety defects (U.S.A.)
If you believe that your vehicle has a defect which could cause a crash or could cause injury or death, you should immediately inform the National Highway Traffic Safety Administration (NHTSA) in ...

Other materials:

Dtc c1411 electrical control module
VEHICLE DYNAMICS CONTROL (VDC) (DIAGNOSTICS) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC C1411 ELECTRICAL CONTROL MODULEDTC detecting condition:Defective VDCCMTrouble symptom:• ABS does not operate.• EBD does not operate.• VDC does not operate.• Hill start ...

Removal
HVAC SYSTEM (HEATER, VENTILATOR AND A/C) > Blower MotorREMOVAL1. Disconnect the ground cable from battery. NOTE">2. Release the clips, and remove the under cover assembly - passenger.3. Remove the blower - motor.(1) Disconnect the connector.(2) Remove the screws and detach the blower - m ...

Disassembly
WIPER AND WASHER SYSTEMS > Wiper BladeDISASSEMBLY1. FRONTPull the side (a) of the wiper rubber stopper, and remove the rubber assembly - windshield wiper from the blade assembly - windshield wiper.2. REARSlightly pull the top of the rubber assembly - rear wiper from the stopper (a), and pull out ...

© 2016-2022 Copyright www.sucross.com