Subaru Crosstrek Service Manual: Telematics system (diagnostics)
- Control module i/o signal
- Diagnostic code(s) display
- Diagnostic procedure with diagnostic trouble code (dtc)
- Dtc b2a01 tel1 antenna circuit
- Dtc u0452 invalid data received from restraints control module
- Dtc b2a02 tel2 antenna circuit
- Dtc u0100 lost communication with ecm/pcm a
- Dtc b2a00 vin reading
- Dtc b2a03 gps antenna circuit
- Dtc b2a04 mic circuit
- Dtc b2a05 left speaker/audio circuit
- Dtc b2a06 right speaker/audio circuit
- Dtc b2a08 sos button circuit
- Dtc b2a09 i-call button circuit
- Dtc b2a0a red led circuit
- Dtc b2a0b green led circuit
- Dtc b2a0c dcm internal fault
- Dtc b2a0d airbag signal
- Dtc b2a0e mute line circuit
- Dtc b2a0f backup battery degradation
- Dtc u0122 lost communication with vehicle dynamics control module
- Dtc u0140 lost communication with body control module
- Dtc u0151 lost communication with restraints control module
- Dtc b2a07 backup battery charge system performance
- Dtc b2a10 battery voltage high
- Dtc u0155 lost communication with instrument panel cluster (ipc) control module
- Dtc u0401 invalid data received from ecm/pcm a
- Dtc u0416 invalid data received from vehicle dynamics control module
- Dtc u0073 control module communication bus off
- Diagnostics with phenomenon
- General description
- Read current data
- Subaru select monitor
- System operation check mode
- Basic diagnostic procedure Procedure
- Check list for interview Check
- Clear memory mode Operation
- Electrical component location Location
- Inspection mode Procedure
Installation
SUNROOF/T-TOP/CONVERTIBLE TOP (SUNROOF) > SunshadeINSTALLATIONCAUTION:For installation of the stereo camera cover assembly, refer to “INSTALLATION”, “Stereo Camera” in the & ...
Other materials:
Installation
LIGHTING SYSTEM > Headlight BulbINSTALLATIONCAUTION:Install so that the front end of the under cover (b) comes inside the bumper face - front (a), and the front end of the mud guard (c) comes outside the bumper face - front (a).1. Install each part in the reverse order of removal.2. When performi ...
If you have accidentally triggered the alarm system
To stop the alarm
Do any of the following operations
Press any button on the access key/
remote transmitter.
Turn the ignition switch to the "ON"
position (models without "keyless access
with push-button start system").
Turn the push-button ignition to the
"ACC" position (models wit ...
Removal
REAR SUSPENSION > Front Lateral LinkREMOVAL1. Lift up the vehicle, and then remove the rear wheels.2. Remove the bolts and nuts, and then remove the trailing link.3. Remove the lateral link assembly - front.(1) Remove the snap pin (a) and nut (b).(2) Remove the ball joint from the housing assembl ...
