WIRING SYSTEM > Basic Diagnostic Procedure
SYMBOLS IN WIRING DIAGRAMS
A number of symbols are used in each wiring diagram to easily identify parts or circuits.
1. RELAY
A symbol used to indicate a relay.
2. CONNECTOR 1
The sketch of the connector indicates the one-pole types.
3. WIRING CONNECTION
Some wiring diagrams are indicated in foldouts for convenience. Wiring destinations are indicated where necessary by corresponding symbols. (When two pages are needed for clear indication)
4. FUSE NO. & RATING
The “FUSE No. & RATING” corresponds with that used in the fuse box (main fuse box, fuse and joint box).
5. CONNECTOR 2
• Each connector is indicated by a symbol.
• Each terminal number is indicated in the corresponding wiring diagram in an abbreviated form.
• For example, terminal number “G4” refers to No. 4 terminal of connector (G: F41) shown in the connector sketch.
6. CONNECTOR SKETCH
• Each connector sketch clearly identifies the shape and color of a connector as well as terminal locations. Non-colored connectors are indicated in natural color.
• When more than two types of connector number are indicated in a connector sketch, it means that the same type connectors are used.
7. GROUND
Each grounding point can be located easily by referring to the corresponding wiring harness.
8. DIODE
A symbol is used to indicate a diode.
9. WIRE TRACING ON EXTENDED WIRING DIAGRAMS
For a wiring diagram extending over at least two pages, a symbol (consisting of the same characters with arrows), facilitates wire tracing from one page to the next.
A ←> A, B ←> B
10. SYMBOLS OF WIRE CONNECTION AND CROSSING
11. POWER SUPPLY CIRCUIT
A symbol is used to indicate the power supply in each wiring diagram.
“MB − 5”, “MB − 6”, etc., which are used as power- supply symbols throughout the text, correspond with those shown in the “DC POWER SUPPLY CIRCUIT” in the wiring diagram.
Accordingly, using the “DC POWER SUPPLY CIRCUIT” and wiring diagrams permits service personnel to understand the entire electrical arrangement of a system.
12. CLASSIFICATION BY SPECIFICATION
When the wiring diagram differ according to vehicle specifications, the specification difference is described by using abbreviations.
13. TWISTED PAIR LINE
The twisted pair line is indicated by a symbol in the wiring diagrams.
Disassembly
CONTINUOUSLY VARIABLE TRANSMISSION(TR580) > Reduction Driven GearDISASSEMBLY1. Flatten the tab of the lock nut.2. Using the ST, counter the rotation of the reduction driven gear assembly, and remove the lock nut.ST1 18355AA000PULLEY WRENCHST2 18334AA000PIN SETST3 499987003SOCKET WRENCH ( ...
Front seatbelts
1. Adjust the seat position according to
the following procedure.
Driver's seat: Adjust the seatback to the
upright position. Move the seat as far from
the steering wheel as practical while still
maintaining full vehicle control.
Front passenger's seat: Adjust the seatback
to the upright ...
Removal
SEATS > Front SeatREMOVALCAUTION:Before handling the airbag system components, refer to “CAUTION” of “General Description” in “AIRBAG SYSTEM”. General Description > CAUTION">1. Remove the headrest assembly - front.2. Turn the ignition switch to OFF. ...