Subaru Crosstrek Service Manual: Switches and harness
Inspection
Blind Spot Detection/Rear Cross Traffic Alert > Switches and Harness
INSPECTION
BSD/RCTA OFF switch
1. Measure the resistance between connector terminals.
Preparation tool:
Circuit tester
Terminal No. | Inspection conditions | Standard |
1 — 2 | Switch OFF | 1 M? or more |
Switch ON | Less than 1 ? |
2. Apply battery voltage between the connector terminals to check lighting condition of illumination inside the switch.
Terminal No. | Inspection conditions | Specification |
3 (+) — 4 (−) | Apply battery voltage. | Light ON |
3. Replace the BSD/RCTA OFF switch if the inspection result is not within the standard value.
Removal
Blind Spot Detection/Rear Cross Traffic Alert > Switches and Harness
REMOVAL
BSD/RCTA OFF switch
1. Disconnect the ground cable from battery and wait for at least 60 seconds before starting work. NOTE">
2. Remove the cover assembly - instrument panel LWR driver OUT. Instrument Panel Lower Cover > REMOVAL">
3. Release the connector locks and claws, and remove the BSD/RCTA OFF switch.
Relay and fuse
Inspection
Blind Spot Detection/Rear Cross Traffic Alert > Relay and FuseINSPECTION1. CHECK FUSE1. Remove the fuse and inspect visually.2. If the fuse is blown out, replace the fuse.NOTE:If the fu ...
Blind spot detection/rear cross traffic alert
Note
Blind Spot Detection/Rear Cross Traffic Alert > Blind Spot Detection/Rear Cross Traffic AlertNOTEFor procedure of each component in the Subaru Rear Vehicle Detection system, refer to the resp ...
Other materials:
Removal
SEAT BELT SYSTEM > Front Seat BeltREMOVAL1. SEAT BELT OUTER - FRONTCAUTION:• Before handling the airbag system components, refer to “CAUTION” of “General Description” in “AIRBAG SYSTEM”. General Description > CAUTION">• Airbag system sat ...
Inspection
GLASS/WINDOWS/MIRRORS > Remote Control Mirror SwitchINSPECTION1. Disconnect the connector of the switch - door mirror.2. Check the resistance between switch - door mirror terminals.Preparation tool:Circuit tester• Changeover switch RHTerminal No.Inspection conditionsStandard — OFF1 M? or ...
Inspection
POWER ASSISTED SYSTEM (POWER STEERING) > Electric Power Steering GearboxINSPECTION1. UNIT INSPECTIONCheck components for wear, damage or other faults. Adjust or replace if necessary.2. LIMITMake a measurements as follows. If it exceeds the specified service limits, adjust or replace.NOTE:When fix ...