Subaru Crosstrek Owners Manual: Stopping engine
- Stop the vehicle completely.
- Move the select lever to the "P" position.
- Press the push-button ignition switch.
The engine will stop, and the power will be switched off.
WARNING
Do not touch the push-button ignition switch during driving.
When the push-button ignition switch is operated as follows, the engine will stop.
- The switch is pressed and held for 3 seconds or longer.
- The switch is pressed briefly 3 times or more in succession.
When the engine stops, the brake booster will not function. A greater foot pressure will be required on the brake pedal.
The power steering system will not operate either. A greater force will be required to steer, and it may result in an accident.
If the engine stops during driving, do not operate the push-button ignition switch or open any of the doors until the vehicle is stopped in a safe location. It is dangerous because the steering lock may be activated. Stop the vehicle in a safe place, and contact a SUBARU dealer immediately.
CAUTION
- Do not stop the engine while the select lever is in a position other than the "P" position.
- If the engine is stopped while the select lever is in a position other than the "P" position, the power will be in "ACC". If the vehicle is left in this condition, the battery may be discharged.
NOTE
Although you can stop the engine by operating the push-button ignition switch, do not stop the engine during driving except in an emergency.
When access key does not operate properly
Refer to "Access key - if access key does not operate properly" F9-17.
Starting engine
WARNING
There are some general precautions
when starting the engine.
Carefully read the precautions
described in "General precautions
when starting/stopping engine"
F7-9.
If the indica ...
Remote engine start system (dealer
option)
WARNING
There are some general precautions
when starting the engine.
Carefully read the precautions
described in "General precautions
when starting/stopping engine"
F7-9.
Do not remote ...
Other materials:
Electrical component location Location
IMMOBILIZER (DIAGNOSTICS) > Electrical Component LocationLOCATION(1)Security indicator light (LED bulb)(3)Data link connector(5)Transponder(2)Body integrated unit(4)Antenna(6)Security control module (for C5 model only) ...
Dtc p2758 torque converter clutch pressure control solenoid control circuit stuck on
CONTINUOUSLY VARIABLE TRANSMISSION (DIAGNOSTICS) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC P2758 TORQUE CONVERTER CLUTCH PRESSURE CONTROL SOLENOID CONTROL CIRCUIT STUCK ONDTC detecting condition:Detected when two consecutive driving cycles with fault occur.Trouble symptom:The e ...
Replacement of wiper blades
Grease, wax, insects, or other material on
the windshield or the wiper blade results in
jerky wiper operation and streaking on the
glass. If you cannot remove the streaks
after operating the windshield washer or if
the wiper operation is jerky, clean the
outer surface of the windshield (or rea ...
