Subaru Crosstrek Service Manual: Stop light brake switch Note
CRUISE CONTROL SYSTEM > Stop Light & Brake Switch
NOTE
For the operation procedures for stop light and brake switch, refer to “BRAKE” section. Stop Light Switch">
Neutral position switch Note
CRUISE CONTROL SYSTEM > Neutral Position SwitchNOTEFor the operation procedures for neutral position switch, refer to “MANUAL TRANSMISSION AND DIFFERENTIAL” section. Switches and Harne ...
Transmission control module (tcm) Note
CRUISE CONTROL SYSTEM > Transmission Control Module (TCM)NOTEFor the operation procedures for transmission control module (TCM), refer to “CONTINUOUSLY VARIABLE TRANSMISSION” section. ...
Other materials:
Dtc u0420 invalid data received from power steering control module
LAN SYSTEM (DIAGNOSTICS) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC U0420 INVALID DATA RECEIVED FROM POWER STEERING CONTROL MODULEDTC DETECTING CONDITION:Defective data was transmitted from EPS CM.TROUBLE SYMPTOM:Cooperation control with EPS CM does not operate properly.STEPCHEC ...
Installation
EXTERIOR/INTERIOR TRIM > Side GarnishINSTALLATIONCAUTION:Do not reuse the garnish assembly. Deformation occurs on the garnish assembly when once removed, and this may cause improper adhesion.1. Install each part in the reverse order of removal.2. Install the garnish assembly - fender and the garn ...
Tips
The system can be armed even if the
engine hood, windows and/or moonroof
are open. Always make sure that they are
fully closed before arming the system.
The 30-second standby time can be
eliminated if you prefer. Have it performed
by your SUBARU dealer.
The system is in the standby ...
