Subaru Crosstrek Service Manual: Steering warning light does not go off

Detecting condition:

• Defective combination meter

• Open circuit of harness

1.CHECK DTC.

Read the DTC of the power steering control module using the Subaru Select Monitor. Read Diagnostic Trouble Code (DTC)">

Is DTC displayed?

Perform the diagnosis according to DTC. List of Diagnostic Trouble Code (DTC)">

STEERING Warning Light > STEERING WARNING LIGHT DOES NOT GO OFF">Go to Step 2.

2.CHECK LAN SYSTEM.

Perform the diagnosis for LAN system using the Subaru Select Monitor. Basic Diagnostic Procedure">

Is a DTC related to CAN communication detected?

Perform the diagnosis according to DTC. List of Diagnostic Trouble Code (DTC)">

Check the combination meter. Combination Meter System > INSPECTION">

Steering warning light does not come on

Subaru select monitor

Other materials:

Removal
LIGHTING SYSTEM > Headlight AssemblyREMOVALCAUTION:• Do not perform work with wet hands, because there is a possibility of electrical shock.• The HID type uses very high voltages for the lighting circuit. Make sure that the power supply is turned OFF before working.1. Disconnect the g ...

Adjustment
EXTERIOR BODY PANELS > Rear DoorADJUSTMENTAdjust the clearance around the panel assembly - rear door as follows.PartStandardAFront door sash to Rear door sash5.5+1.5, −1.0 mm (0.22+0.06, −0.04 in)BPanel assembly - front door to Panel assembly - rear door4.5±1.0 mm (0.18±0.04 in)CRoo ...

Dtc b1693 door sensor rh initialization incomplete
AIRBAG SYSTEM (DIAGNOSTICS) > Diagnostic Chart with Trouble CodeDTC B1693 DOOR SENSOR RH INITIALIZATION INCOMPLETEDiagnosis start condition:Ignition voltage is 10 V to 16 V.DTC detecting condition:• Open or short circuit in harness of side sensor bus (RH)• Front door impact sensor (RH ...