1. Apply the parking brake.
2. Shift the select lever into the "P" position.
3. Depress the brake pedal.
4. Hold the access key with the buttons facing you, and touch the push-button ignition switch with it.
When the communication between the access key and the vehicle is completed, a chime (ding) will sound. At the same time, the push-button ignition switch turns to the "ACC" or "ON" position.
5. After the push-button ignition switch turns to the "ACC" or "ON" position, while depressing the brake pedal, press the push-button ignition switch.
NOTE
If the engine does not start even though the above procedure was followed precisely, contact your SUBARU dealer.
Dtc b14a1 sunload sensor circuit low/open
HVAC SYSTEM (AUTO A/C) (DIAGNOSTICS) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC B14A1 SUNLOAD SENSOR CIRCUIT LOW/OPENDTC detecting condition:Sunload sensor circuit is open. (Displayed for current malfunction)NOTE:When the sunload sensor check is performed indoors or in the shade ...
Disassembly
MANUAL TRANSMISSION AND DIFFERENTIAL(5MT) > Front Differential AssemblyDISASSEMBLY1. DIFFERENTIAL CASE ASSEMBLY1. Remove the twelve bolts and remove hypoid driven gear.(A)Hypoid driven gear2. Drive out the straight pin from differential assembly toward hypoid driven gear side.ST 899904100STRAI ...
Continuously variable transmission
WARNING
Do not shift from the "P" or "N"
position into the "D" or "R" position
while depressing the accelerator
pedal. This may cause the vehicle
to jump forward or backward.
CAUTION
Observe the following precautions.
Failure to observe these
precautions could cause damage
to the transmi ...