
SRS airbag system warning light (type B)
A diagnostic system continually monitors the readiness of the SRS airbag system (including front seatbelt pretensioners) while the vehicle is being driven. The SRS airbag system warning light will show normal system operation by illuminating for approximately 6 seconds when the ignition switch is turned to the "ON" position.
The following components are monitored by the indicator:
Front sub sensor
Airbag control module (including impact sensor and rollover sensor)
Frontal airbag module
Knee airbag module (driver's side)
Side airbag sensor
Front door impact sensor
Side airbag module
Curtain airbag sensor
Curtain airbag module
Satellite safing sensor (under the rear center seat)
Seatbelt pretensioner
Lap belt pretensioner (front passenger's side)
Seatbelt buckle switch (front passenger's side)
Front passenger's occupant detection system sensor
Front passenger's occupant detection control module
Front passenger's frontal airbag ON and OFF indicator
All related wiring
WARNING
If the warning light exhibits any of the following conditions, there may be a malfunction in the seatbelt pretensioners and/or SRS airbag system.
Immediately take your vehicle to your nearest SUBARU dealer to have the system checked. Unless checked and properly repaired, the seatbelt pretensioners and/or SRS airbag will not operate properly in the event of a collision, which may increase the risk of injury.
SRS side airbag and SRS curtain airbag
SRS airbag system servicingTrailer lights
CAUTION
Direct splicing or other improper
connection of trailer lights may
damage your vehicle's electrical
system and cause a malfunction of
your vehicle's lighting system.
Connection of trailer lights to your vehicle's
electrical system requires modifications
to the vehicle's lighting circ ...
Interior light system Wiring diagram
WIRING SYSTEM > Interior Light SystemWIRING DIAGRAM1. WITHOUT EyeSight2. WITH EyeSight ...
Note
SECURITY AND LOCKS > Body Integrated UnitNOTE1. REPLACE BODY INTEGRATED UNIT1. Check and record the current setting. Registration Body Integrated Unit > OPERATION">2. Prepare all immobilizer keys already registered. (Models without the keyless access with push button start)3. Replace ...