Subaru Crosstrek Service Manual: Specification
VEHICLE DYNAMICS CONTROL (VDC) > ABS Sequence Control
SPECIFICATION
1. CONDITIONS FOR COMPLETION OF ABS SEQUENCE CONTROL
When the following conditions develop, the ABS sequence control stops and ABS operation is returned to the normal control mode.
• When the speed of at least one wheel reaches 10 km/h (6 MPH).
• When the brake pedal is released during ABS sequence control and the switch - stop light becomes OFF.
• After completion of ABS sequence control.
• When a malfunction is detected.
Operation
VEHICLE DYNAMICS CONTROL (VDC) > ABS Sequence ControlOPERATION1. While the ABS sequence control is being performed, the operation of the hydraulic unit can be checked using the brake tester or pres ...
Other materials:
Installation
CLUTCH SYSTEM > Clutch PedalINSTALLATION1. Install in the reverse order of removal.CAUTION:Always use a new clevis pin.Tightening torque:Clutch pedal18 N·m (1.8 kgf-m, 13.3 ft-lb)Knee airbag module7.5 N·m (0.76 kgf-m, 5.5 ft-lb)Air intake boot3 N·m (0.3 kgf-m, 2.2 ft-lb)2. Ad ...
Dtc p0351 ignition coil "a" primary control circuit/open
ENGINE (DIAGNOSTICS)(H4DO) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC P0351 IGNITION COIL "A" PRIMARY CONTROL CIRCUIT/OPENDTC detecting condition:Immediately at fault recognitionTrouble symptom:• Improper idling• Poor driving performanceCAUTION:After servic ...
Installation
SECURITY AND LOCKS > Accessory Relay (Push Button Start)INSTALLATIONCAUTION:Before handling the airbag system components, refer to “CAUTION” of “General Description” in “AIRBAG SYSTEM”. General Description > CAUTION">Install each part in the reverse ...
