Subaru Crosstrek Service Manual: Specification
TELEMATICS SYSTEM (DIAGNOSTICS) > Control Module I/O Signal
SPECIFICATION
1. DATA COMMUNICATION MODULE (DCM)
Terminal No. | Content | Measuring condition | Standard |
A1 | — | — | — |
A2 | — | — | — |
A3 | LED GREEN | — | — |
A4 ←> Chassis ground | i-button | i-button OFF > ON | 1.6 k? or more > less than 1 ? |
A5 ←> Chassis ground | SOS button | SOS button OFF > ON | 1.6 k? or more > less than 1 ? |
A6 | — | — | — |
A7 | CAN L | — | — |
A8 | Ignition power supply | Ignition switch OFF > ON | Less than 1 V > 9 — 16 V |
A9 | — | — | — |
A10 | Battery power supply | Always | 9 — 16 V |
A11 | — | — | — |
A12 | — | — | — |
A13 | LED RED | — | — |
A14 ←> Chassis ground | GND | Always | Less than 1 ? |
A15 | — | — | — |
A16 | — | — | — |
A17 | CAN H | — | — |
A18 | Airbag communication line | — | — |
A19 | MUTE | — | — |
A20 ←> Chassis ground | ACC | Ignition switch OFF > ACC ON | Less than 1 V > 9 — 16 V |
B1 | Front speaker input LH − | — | — |
B2 | Front speaker output LH − | — | — |
B3 | Front speaker input RH − | — | — |
B4 | Front speaker output RH − | — | — |
B5 | MIC signal OUT | — | — |
B6 | MIC signal | — | — |
B7 | MIC DET | — | — |
B8 | MIC 5 V | — | — |
B9 | Front speaker input LH + | — | — |
B10 | Front speaker output LH + | — | — |
B11 | Front speaker input RH + | — | — |
B12 | Front speaker output RH + | — | — |
B13 ←> Chassis ground | MIC GND OUT | Always | Less than 1 ? |
B14 | MIC GND IN | — | — |
B15 | — | — | — |
B16 | — | — | — |
System block diagram
TELEMATICS SYSTEM (DIAGNOSTICS) > Control Module I/O SignalSYSTEM BLOCK DIAGRAMMain signals used between DCM and relevant CM ...
Other materials:
Disassembly
MANUAL TRANSMISSION AND DIFFERENTIAL(5MT) > Center DifferentialDISASSEMBLYRemove the ball bearing using ST.NOTE:Center differential is a non-disassembled part which should not be disassembled.ST 498077300CENTER DIFFERENTIAL BEARING REMOVER ...
Time lag test Inspection
CONTINUOUSLY VARIABLE TRANSMISSION(TR580) > Time Lag TestINSPECTIONNOTE:When the select lever is shifted while the engine is idling, there will be a certain time elapse or lag before shock is felt. This symptom helps to check the condition of forward clutch and reverse brake.• Perform the t ...
Dtc p0512 starter (switch) request circuit
ENGINE (DIAGNOSTICS)(H4DO) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC P0512 STARTER (SWITCH) REQUEST CIRCUITDTC detecting condition:Immediately at fault recognitionTrouble symptom:Failure of engine to startCAUTION:After servicing or replacing faulty parts, perform Clear Memory M ...
