Subaru Crosstrek Service Manual: Specification
FRONT SUSPENSION > General Description
SPECIFICATION
Tire size | P225/55R17 225/55R17 | ||
Front | Wheel arch height | 452 (17.8) | |
(Tolerance: +12 mm −24 mm (+0.47 in −0.94 in)) | mm (in) | ||
Camber (tolerance: ±0°45' Differences between RH and LH: 45' or less) | 0°10' | ||
Caster (referential value) | 5°60' | ||
Steering angle (tolerance: ±1.5°) | Inner wheel | 38.5° | |
Outer wheel | 34.0° | ||
Toe-in | mm (in) | 0±3 (0±0.12) Toe angle (sum of both wheels): 0°±0°10' | |
Kingpin angle (referential value) | 13°05' | ||
Rear | Wheel arch height | 450 (17.72) | |
(Tolerance: +12 mm −24 mm (+0.47 in −0.94 in)) | mm (in) | ||
Camber (tolerance: +0°45' −0°52' (Differences between RH and LH: 45' or less)) | −0°25' | ||
Toe-in | mm (in) | 0±3 (0±0.12) Toe angle (sum of both wheels): 0°00'±10' | |
Thrust angle (tolerance: 0°00'±30') | 0°00' | ||
NOTE:
• Adjust with the value less than the inspection value, taking aging variation into consideration.
• Front toe-in, rear toe-in and front camber can be adjusted. Adjust if the value of toe-in or camber exceeds the tolerance range of the specification chart.
• Other items except for front toe-in, rear toe-in and front camber that are described in the specification chart cannot be adjusted. If other items exceed the tolerance range of the specification chart, check the suspension parts and connections for deformation. If defective, replace with new parts.
A − B = Positive: Toe-in, Negative: Toe-out
α = Individual toe angles
Caution
FRONT SUSPENSION > General DescriptionCAUTION• Wear appropriate work clothing, including a helmet, protective goggles and protective shoes when performing any work.• Before removal, ins ...
Component
FRONT SUSPENSION > General DescriptionCOMPONENT1. FRONT SUSPENSION(1)Front crossmember COMPL(14)Bushing rear - front arm(27)Clip(2)Flange bolt(15)Stud bolt (3)Front crossmember support(16)Stopper ...
Other materials:
Removal
LUBRICATION(H4DO) > Oil Pressure SwitchREMOVALCAUTION:If the engine oil is spilt over exhaust pipe or the under cover, wipe it off with cloth to avoid emitting smoke or causing a fire.1. Disconnect the ground cable from battery. NOTE">2. Remove the rubber cap.3. Disconnect the terminal f ...
Dtc u0122 lost communication with vehicle dynamics control module
ENGINE (DIAGNOSTICS)(H4DO) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC U0122 LOST COMMUNICATION WITH VEHICLE DYNAMICS CONTROL MODULENOTE:For the diagnostic procedure, refer to LAN section. Basic Diagnostic Procedure">1. OUTLINE OF DIAGNOSISDetect malfunction of CAN commu ...
Removal
EXTERIOR/INTERIOR TRIM > Roof RailREMOVAL1. Remove the trim panel - roof. Roof Trim > REMOVAL">2. Remove the curtain airbag module. Curtain Airbag Module > REMOVAL">CAUTION:• Before handling the airbag system components, refer to “CAUTION” of “Gener ...
