Subaru Crosstrek manuals

Subaru Crosstrek Service Manual: Specification

CONTROL SYSTEMS > General Description

SPECIFICATION

Item

Specifications

Swing torque of rod against lever

N (kgf, lb)

3.7 (0.38, 0.83) or less

Caution
CONTROL SYSTEMS > General DescriptionCAUTION• Wear appropriate work clothing, including a cap, protective goggles and protective shoes when performing any work.• Remove contamination in ...

Component
CONTROL SYSTEMS > General DescriptionCOMPONENT1. AT SELECT LEVER(1)Grip sub ASSY (model with gate shifter)(14)Spacer pin guide(27)Nut(2)Clamp grip pin(15)Plate COMPL(28)Button ASSY-AT(3)Cover grip ...

Other materials:

Starting and stopping the engine (models without push-button start system)
CAUTION When operating the Subaru Ascent starter motor, never crank the engine continuously for more than 10 seconds. If the engine of the Subaru Ascent does not start within 5 to 10 seconds, stop cranking and wait at least 10 seconds before attempting again. This pause helps prevent overh ...

Dtc p2127 throttle/pedal position sensor/switch "e" circuit low
ENGINE (DIAGNOSTICS)(H4DO) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC P2127 THROTTLE/PEDAL POSITION SENSOR/SWITCH "E" CIRCUIT LOWDTC detecting condition:Immediately at fault recognitionTrouble symptom:• Improper idling• Poor driving performanceCAUTION:After ...

Airbag connector Procedure
AIRBAG SYSTEM > Airbag ConnectorPROCEDURE1. POWER SUPPLY1. How to disconnect:CAUTION:When pulling the slide lock or disconnecting connector, be sure to hold the connector, not the harness.(1) Push the lock (a).(2) While holding down the lock (a), disconnect the connector.2. How to connect:CAUTION ...

© 2016-2026 Copyright www.sucross.com