Subaru Crosstrek Owners Manual: Sounding a panic alarm
To activate the alarm, press the "PANIC" button once.
The horn will sound and the hazard warning flashers will flash.
To deactivate the panic alarm, press any button on the remote transmitter. Unless a button on the remote transmitter is pressed, the alarm will be deactivated after approximately 30 seconds.
Vehicle finder function
Use this function to find your vehicle
parked among many vehicles in a large
parking lot. Provided you are within 30 feet
(10 meters) of the vehicle, pressing the
lock/arm button three times in a ...
Selecting audible signal operation (models without "keyless access with
push-button start system")
Using an electronic chirp, the system will
give you an audible signal when the doors
lock and unlock. If desired, you may turn
the audible signal off.
Perform the following steps to deactivate
...
Other materials:
Installation
FUEL INJECTION (FUEL SYSTEMS)(H4DO) > Fuel Filler PipeINSTALLATION1. Open the fuel filler lid.2. Insert the fuel filler pipe assembly into the rubber saucer from inside of the rear fender.3. Install the fuel filler pipe assembly to the vehicle.Tightening torque:7.5 N·m (0.8 kgf-m, 5.5 ft-l ...
Check list for interview Check
INSTRUMENTATION/DRIVER INFO (DIAGNOSTICS) > Check List for InterviewCHECK• Inspect the following items regarding the vehicle’s state.• Print out this page for interviewing customers.Combination Meter / MFD Check List for Interview Date the ...
Daytime running light system
WARNING
The brightness of the illumination of
the high beam headlights is reduced
by the daytime running light system.
The light switch must always be
turned to the " " position when it
is dark outside.
The high beam headlights will automatically
illuminate at reduced brightness
when the ...