In service mode, the remote engine start function is temporarily disabled to prevent the system from unexpectedly starting the engine while being serviced.
To engage or disengage service mode: 1. Enter the vehicle and close all vehicle doors and the rear gate.
2. Verify that the select lever is in the "P" position (CVT models)
3. Depress and hold the brake pedal
4. Turn the ignition switch to the "ON"
position
5. Press and release the remote engine
start transmitter " " button three
times.
The system will honk the vehicle's horn each time the button is pressed.
6. The system will pause for 1 second then honk the vehicle's horn three times to indicate that the service mode has been engaged or honk one time to indicate that the service mode has been disengaged.
NOTE
When taking your vehicle in for service, it is recommended that you inform the service personnel that your vehicle is equipped with a remote engine start system.
Transmission
SPECIFICATIONS > CrosstrekTRANSMISSION1. MTModel2.0 L DOHC non-turboTransmission type5MTClutch typeDSPDGear ratio1st3.5452nd1.8883rd1.2964th0.9725th0.780Rev.3.333Reduction gear (front)Type of gearHypoidGear ratio4.444Transfer reductionType of gearHelicalGear ratio1.000Reduction gear (rear)Final r ...
Removal
SUNROOF/T-TOP/CONVERTIBLE TOP (SUNROOF) > SunshadeREMOVAL1. Disconnect the ground cable from battery and wait for at least 60 seconds before starting work. NOTE">2. Remove the lid assembly - sunroof. Glass Lid > REMOVAL">3. Remove the trim panel - roof assembly. Roof Trim &g ...
Basic diagnostic procedure Procedure
KEYLESS ACCESS WITH PUSH BUTTON START SYSTEM (DIAGNOSTICS) > Basic Diagnostic ProcedurePROCEDURECAUTION:• Subaru Select Monitor kit is required for reading DTC, performing diagnosis and reading current data.• Before removal or installation, be sure to remove any foreign matter (dust, ...