Subaru Crosstrek manuals

Subaru Crosstrek Owners Manual: Selecting audible signal operation (models without "keyless access with push-button start system")

Subaru Crosstrek Owners Manual / Keys and doors / Remote keyless entry system / Selecting audible signal operation (models without "keyless access with push-button start system")

Using an electronic chirp, the system will give you an audible signal when the doors lock and unlock. If desired, you may turn the audible signal off.

Perform the following steps to deactivate the audible signal. You can also use the same steps to restore the function.

1. Sit in the driver's seat and shut all doors and the rear gate.

Selecting audible signal operation (models without

2. Hold down the REAR (UNLOCK) side of the power door locking switch.

3. While holding down the REAR (UNLOCK) side of the power door locking switch, pull the key out and re-insert it into the ignition switch at least 6 times within 10 seconds after Step 2.

4. Open and close the driver's door once within 10 seconds after Step 3.

5. The hazard warning flashers flash 3 times to indicate completion of the setting.

You may have the above settings done by your SUBARU dealer. Also, for models with a multi function display, the setting can be changed using the display. For details, refer to "Keyless buzzer volume setting" 3-78.

Replacing the battery

Refer to "Replacing key battery"

Sounding a panic alarm
To activate the alarm, press the "PANIC" button once. The horn will sound and the hazard warning flashers will flash. To deactivate the panic alarm, press any button on the remote transmitter ...

Replacing lost transmitters
If you lose a transmitter or want to purchase additional transmitters (up to four can be programmed), your transmitters should be reprogrammed for security reasons. For details, contact your SUBA ...

Other materials:

Clear memory mode Operation
CONTINUOUSLY VARIABLE TRANSMISSION (DIAGNOSTICS) > Clear Memory ModeOPERATION1. On «Start» display, select «Diagnosis».2. On «Vehicle selection» display, input the vehicle information and select «Confirmed».3. On «Main Menu» display, select «Each System».4. On «Select System» displa ...

Dtc b1574 key communication
IMMOBILIZER (DIAGNOSTICS) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC B1574 KEY COMMUNICATIONDTC DETECTING CONDITION:Communication failure between key and body integrated unitCAUTION:When the body integrated unit is replaced, registration of the immobilizer system is required. Fo ...

Replacing bulbs
WARNING Bulbs may become very hot while illuminated. Before replacing bulbs, turn off the lights and wait until the bulbs cool down. Otherwise, there is a risk of sustaining a burn injury. CAUTION Replace any bulb only with a new bulb of the specified wattage. Using a bulb of differe ...

© 2016-2022 Copyright www.sucross.com