Subaru Crosstrek manuals

Subaru Crosstrek Owners Manual: Select lever/gear position indicator (CVT models)

Subaru Crosstrek Owners Manual / Instruments and controls / Warning and indicator lights / Select lever/gear position indicator (CVT models)

Type A

Type A

  1. Upshift indicator
  2. Downshift indicator
  3. Select lever/gear position indicator

Type B

Type B

  1. Upshift indicator
  2. Downshift indicator
  3. Select lever/gear position indicator

This indicator shows the position of the select lever.

When the manual mode is selected, the gear position indicator (which shows the current gear selection) and the upshift/ downshift indicator light up. Refer to "Continuously variable transmission"

Turn signal indicator lights

These lights show the operation of the turn signal or lane change signal.

If the indicator lights do not blink or blink rapidly, the turn signal bulb may be burned out. Replace the bulb as soon as possible.

Refer to "Replacing bulbs"

High beam indicator light

This light shows that the headlights are in the high beam mode.

This indicator light also illuminates when the headlight flasher is operated.

Security indicator light
This indicator light shows the status of the alarm system. It also indicates operation of the immobilizer system. Alarm system It blinks to show the driver the operational status of the alarm sys ...

Cruise control indicator light (if equipped)
This light illuminates when the cruise control main button is pressed to activate the cruise control function. For details, refer to "To set cruise control" CAUTION If the CHECK ENGINE warnin ...

Other materials:

Removal
VEHICLE DYNAMICS CONTROL (VDC) > VDC OFF SwitchREMOVAL1. Disconnect the ground cable from battery. NOTE">2. Remove the cover assembly - instrument panel LWR driver OUT. Instrument Panel Lower Cover > REMOVAL">3. Remove the screws and release the claws, then detach the cover.4 ...

Dtc c0057 ecm communication circuit
VEHICLE DYNAMICS CONTROL (VDC) (DIAGNOSTICS) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC C0057 ECM COMMUNICATION CIRCUITDTC detecting condition:No CAN signal from ECM.Trouble symptom:• VDC does not operate.• EyeSight does not operate.STEPCHECKYESNO1.CHECK LAN SYSTEM.P ...

Preparation for date setting
Turn the ignition switch to the "ON" position. Push and hold the button to show the selection screen.  After the selection screen is displayed, operate the " " or " " switch to show the "Time/Date" item. Then, push the button. ...

© 2016-2022 Copyright www.sucross.com