Subaru Crosstrek Service Manual: Select lever

Installation

CONTROL SYSTEMS > Select CableINSTALLATION1. Position the select cable as shown in the figure, and install it to the plate assembly.CAUTION:• If the cable is installed in the wrong direction, ...

Assembly

CONTROL SYSTEMS > Select LeverASSEMBLY1. Clean all the parts before assembly.2. Apply Multemp D or equivalent to the sliding portion of each part.3. Assemble in the reverse order of disassembly.NOT ...

Other materials:

Defogger setting
1. Perform the preparation steps according to "Preparation for car settings" 2. Operate the " " or "  " switch to select the "Defogger" item. Then push the button. 3. The current setting will be displayed. Push the  button to enter the selection mode. 4. Select ...

Installation
FUEL INJECTION (FUEL SYSTEMS)(H4DO) > Engine Wiring HarnessINSTALLATION1. Route the engine wiring harness around the engine and connect connectors.• Structural diagram 1(1)Tumble generator valve actuator RH(2)Be careful of pinching when installing the intake manifold.(3)Engine harness conne ...

Dtc p2404 evap system leak detection pump sense circuit range/performance
ENGINE (DIAGNOSTICS)(H4DO) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC P2404 EVAP SYSTEM LEAK DETECTION PUMP SENSE CIRCUIT RANGE/PERFORMANCEDTC detecting condition:Detected when two consecutive driving cycles with fault occur.CAUTION:After servicing or replacing faulty parts, per ...