Subaru Crosstrek Service Manual: Security and locks
- Access buzzer
- Access key
- Accessory relay (push button start)
- Body integrated unit
- Door lock control system
- Front door latch and door lock actuator assembly
- Front hood lock assembly
- Front inner remote
- Front outer handle
- Function setting (customize)
- General description
- Ig relay1 (push button start)
- Ig relay2 (push button start)
- Ignition key lock
- Immobilizer antenna
- Impact sensor
- Keyless access cm
- Keyless access indoor antenna
- Keyless access outdoor antenna
- Keyless access system
- Keyless buzzer
- Keyless entry control module
- Keyless entry system
- Keyless transmitter
- Push button ignition switch
- Push button start system
- Rear door latch and door lock actuator assembly
- Rear gate latch and actuator assembly
- Rear gate opener button
- Rear inner remote
- Rear lock button
- Rear outer handle
- Receiver
- Relay and fuse
- Remote openers
- Security control module
- Security system
- Starter cut relay
- Starter relay (push button start)
- Steering lock cm
- Id code box Note
- Immobilizer control module Note
- Key lock cylinders Replacement
- Keyless access with push button start system Diagnostic procedure with phenomenon
Installation
SEATS > Seat Heater SystemINSTALLATIONCAUTION:• If the cover - front cushion is removed, make sure to replace the hang wire on the cover - front cushion side with a new wire.• When repl ...
Access buzzer
...
Other materials:
Installation
CLUTCH SYSTEM > Clutch SwitchINSTALLATION1. CLUTCH SWITCH1. Install the clutch switch.2. Move the clevis pin of push rod to left and right, retain it at the position where it moves smoothly, and measure the clutch pedal stroke.Clutch pedal full stroke A:130 — 135 mm (5.12 — 5.31 in)Tightening ...
Replacement
DIFFERENTIALS > Rear Differential Mount BushingREPLACEMENTCAUTION:• If there was so much rust in the rear differential mount bushing, remove the rust before starting work.• Apply the molybdenum grease on the square thread of the ST (shaft and nut) before use.1. Remove the rear differe ...
Removal
FRONT SUSPENSION > Front ArmREMOVAL1. Lift up the vehicle, and then remove the front wheels.2. Remove the under cover - front. Front Under Cover > REMOVAL">3. Remove the front arm assembly.(1) Remove the bolt, and then detach the front support. (Electric power steering model only)(2) ...
