Subaru Crosstrek Owners Manual: Seat, seatbelt and SRS airbags
- Front seats
- Forward and backward adjustment
- Reclining the seatback
- Seat height adjustment (driver's seat)
- Head restraint adjustment
- Seat heater (if equipped)
- Rear seats
- Seatbelts
- Seatbelt safety tips
- Automatic Locking Retractor/Emergency Locking Retractor (ALR/ELR)
- Fastening the seatbelt
- Seatbelt maintenance
- Front seatbelt pretensioners
- Driver's seatbelt
- Front passenger's seatbelt
- System monitors
- System servicing
- Precautions against vehicle modification
- Child restraint systems
- Where to place a child restraint system
- Choosing a child restraint system
- Installing child restraint systems with ALR/ELR seatbelt
- Installing a booster seat
- Installation of child restraint systems by use of lower and tether anchorages (LATCH)
- Top tether anchorages
- SRS airbag (Supplemental Restraint System airbag)
Function settings
A SUBARU dealer can change the settings of the functions shown in the
following table to meet your personal requirements. Contact
the nearest SUBARU dealer for details. If your vehicle is equipped ...
Front seats
WARNING
Never adjust the seat while driving
to avoid loss of vehicle control
and personal injury.
Before adjusting the seat, make
sure the hands and feet of rear
seat passengers and carg ...
Other materials:
Installation
SECURITY AND LOCKS > Steering Lock CMINSTALLATIONCAUTION:• When the control module related to immobilizer has been replaced, be sure to perform the registration of immobilizer system. For detailed operation procedure, refer to “Type D” described in “REGISTRATION MANUAL FOR ...
Adjustment
CONTINUOUSLY VARIABLE TRANSMISSION(TR580) > Reduction Driven GearADJUSTMENT1. Measure the height “A” from the ST upper face to the ball bearing catch surface.ST 499575600GAUGE2. Measure the height “B” from the ST to the mating surface of the transmission case.ST 4995 ...
Removal
EXTERIOR/INTERIOR TRIM > Front BumperREMOVAL1. Disconnect the ground cable from battery. NOTE">2. Remove the bumper face - front.(1) Remove the screw and clips, and turn over the mud guard - front.(2) Disconnect the connectors of the left and right fog light assembly - front. (Model with ...
