Subaru Crosstrek manuals

Subaru Crosstrek Owners Manual: Screen settings

The items in screen settings can be set.

To change the items, operate the "" or " " switch, and then push the button.

Beep volume setting
1. Perform the preparation steps according to "Preparation for image quality and volume settings" 2. Operate the " " or " " switch to select the "Beep" item. Then push the button. ...

Preparation for screen settings
1. Turn the ignition switch to the "ON" position. 2. Push and hold the button to show the selection screen. 3. After the selection screen is displayed, operate the "  " or " ...

Other materials:

Removal
EXTERIOR/INTERIOR TRIM > Sun VisorREMOVAL1. Remove the sun visor assembly.(1) Remove the cap - sun visor, and then remove the screws.(2) Disconnect the connector and remove the sun visor assembly.2. Remove the hook - sun visor.(1) Press both sides using a flat tip screwdriver.(2) Remove the hook ...

Removal
INSTRUMENTATION/DRIVER INFO > Combination MeterREMOVAL1. Disconnect the ground cable from battery. NOTE">2. Release the lock, tilt the steering column to the lowest end and fully extend the column by the telescopic system.3. Release the screws, clips and claws, and remove the visor - com ...

Control module i/o signal Electrical specification
BODY CONTROL SYSTEM (DIAGNOSTICS) > Control Module I/O SignalELECTRICAL SPECIFICATIONDescriptionTerminal No.Signal (V or ?)NoteIgnition switch ON(Engine OFF)Ignition power supply (rear wiper)A5 ←> Chassis groundLess than 1.5 V > 10 — 13 VIgnition switch OFF > ONBattery power suppl ...

© 2016-2026 Copyright www.sucross.com