After entering the "Screen Settings" menu, select one of the following menus.
Welcome Good-bye Screen
The welcome screen/good-bye screens can be activated or deactivated. Select "On" to activate the screens. Select "Off" to deactivate the screens.
Gauge Initial Movement
The movement of the meter needles and gauge needles that occurs when the ignition switch is turned to the "ON" position can be activated or deactivated.
Select "On" to activate. Select "Off" to deactivate.
Languages
Operate the " " or " " switch on the steering wheel to display the preferred language. Then pull the " /SET" switch to select the displayed language.
Locking and unlocking from the inside
Unlock
Lock
To lock the door from the inside, rotate the
lock lever forward. To unlock the door from
the inside, rotate the lock lever rearward.
The red mark on the lock lever appears
when the door is unlocked.
Pull the inside door handle to open an
unlocked door.
Always mak ...
Read diagnostic trouble code (dtc) Operation
Blind Spot Detection/Rear Cross Traffic Alert (DIAGNOSTICS) > Read Diagnostic Trouble Code (DTC)OPERATION1. On «Start» display, select «Diagnosis».2. On «Vehicle selection» display, input the target vehicle information and select «Confirmed».3. On «Main Menu» display, select «Each Syst ...
Preparation tool
MECHANICAL(H4DO) > General DescriptionPREPARATION TOOL1. SPECIAL TOOLILLUSTRATIONTOOL NUMBERDESCRIPTIONREMARKS0920287002000REMOVER AND REPLACERUsed for removing and installing valve spring.498277200STOPPER SETUsed for preventing the torque converter from falling when removing and installing the e ...