Subaru Crosstrek manuals

Subaru Crosstrek Owners Manual: Safety precautions

WARNING

Bulbs may become very hot while illuminated. Before replacing bulbs, turn off the lights and wait until the bulbs cool down. Otherwise, there is a risk of sustaining a burn injury.

For models with HID low beam headlights, observe the following precautions. Not doing so carries the risk of an electric shock that could result in serious injury because the HID bulbs use an extremely high voltage.

For replacement, contact your SUBARU dealer.

CAUTION

Replace any bulb only with a new bulb of the specified wattage. Using a bulb of different wattage could result in a fire.

Bulb chart
...

Bulb chart
NOTE Lights A and B are the LED (Light Emitting Diode) type. Consult your SUBARU dealer for replacement.   Wattage Bulb No. 1) High beam headlight 12V-60W HB3 ...

Other materials:

Dtc u0073 control module communication bus off
Blind Spot Detection/Rear Cross Traffic Alert (DIAGNOSTICS) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC U0073 CONTROL MODULE COMMUNICATION BUS OFFDetected when CAN line abnormality is detected.NOTE:Perform the diagnosis for LAN system. Basic Diagnostic Procedure > PROCEDURE&q ...

Installation
DRIVE SHAFT SYSTEM > Front Drive ShaftINSTALLATION1. Before installation, check the drive shaft assembly. Front Drive Shaft > INSPECTION">2. Replace the differential side retainer oil seal with a new part.• MT model: Differential Side Retainer Oil Seal > REPLACEMENT"> ...

Seatbelt warning light and chime
Your vehicle is equipped with a seatbelt warning device at the driver's and front passenger's seat, as required by current safety standards. With the ignition switch turned to the "ON" position, this device reminds the driver and front passenger to fasten their seatbelts by illuminating ...

© 2016-2026 Copyright www.sucross.com