WARNING
Always use the utmost care in driving - overconfidence because you are driving a vehicle with the Vehicle Dynamics Control system could easily lead to a serious accident.
CAUTION
Even if your vehicle is equipped with Vehicle Dynamics Control system, winter tires should be used when driving on snow-covered or icy roads; in addition, vehicle speed should be reduced considerably. Simply having a Vehicle Dynamics Control system does not guarantee that the vehicle will be able to avoid accidents in any situation.
Activation of the Vehicle Dynamics Control system is an indication that the road being travelled on has a slippery surface; since having Vehicle Dynamics Control is no guarantee that full vehicle control will be maintained at all times and under all conditions, its activation should be seen as a sign that the speed of the vehicle should be reduced considerably.
Whenever suspension components, steering components, or an axle are removed from a vehicle, have an inspection of that system performed by an authorized SUBARU dealer.
The following precautions should be observed in order to ensure that the Vehicle Dynamics Control system is operating properly:
If non-matching tires are used, the Vehicle Dynamics Control system may not operate correctly.
The Vehicle Dynamics Control system helps prevent unstable vehicle motion such as skidding using control of the brakes and engine power. Do not turn off the Vehicle Dynamics Control system unless it is absolutely necessary.
If you must turn off the Vehicle Dynamics Control system, drive very carefully according to the road surface conditions.
System featuresRemoval
ENTERTAINMENT > AntennaREMOVAL1. RADIO/TELEMATICS ANTENNACAUTION:Before handling the airbag system components, refer to “CAUTION” of “General Description” in “AIRBAG SYSTEM”. General Description > CAUTION">1. Disconnect the ground cable from battery ...
Installation
FRONT SUSPENSION > Front Crossmember Support PlateINSTALLATIONCAUTION:Install so that the front end of the under cover (b) comes inside the bumper face - front (a), and the front end of the mud guard (c) comes outside the bumper face - front (a).Install each part in the reverse order of removal.T ...
Inspection
WIPER AND WASHER SYSTEMS > Rear Wiper MotorINSPECTIONCAUTION:Fix the motor to prevent the motor from being shorted by moving during operation.1. Connect the battery to the motor assembly - rear wiper connector, and check that the motor assembly - rear wiper operates.2. Connect the battery to term ...