Subaru Crosstrek Owners Manual: Roof antenna (for Rod type)
CAUTION
- Be sure to remove the antenna rod before entering garages, parking towers and other locations with low ceilings.
- Remove the antenna rod before washing your car at a car wash. If the antenna rod is left attached, it may scratch the roof.
- When reinstalling the removed antenna rod, be sure to fully tighten it.
- Unscrew
- Remove
The roof antenna is installed in the center at the rear part of the roof.
The antenna rod can be removed by unscrewing it from its base.
Antenna
...
Roof antenna (for Shark fin type)
The radio antenna, satellite radio antenna
and telematics antenna (if equipped) are
installed in the center of the roof at the
rear. ...
Other materials:
Installation
SECURITY AND LOCKS > Front Outer HandleINSTALLATION1. Before installation, check the following items.• Rod is free from deformation.• Grease is applied sufficiently to rod joints.If grease is insufficient, add it as necessary before assembling the rod.• If the lever is faulty, r ...
Installation
CLUTCH SYSTEM > Clutch PedalINSTALLATION1. Install in the reverse order of removal.CAUTION:Always use a new clevis pin.Tightening torque:Clutch pedal18 N·m (1.8 kgf-m, 13.3 ft-lb)Knee airbag module7.5 N·m (0.76 kgf-m, 5.5 ft-lb)Air intake boot3 N·m (0.3 kgf-m, 2.2 ft-lb)2. Ad ...
Dtc p0030 a/f / o2 heater control circuit bank 1 sensor 1
ENGINE (DIAGNOSTICS)(H4DO) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC P0030 A/F / O2 HEATER CONTROL CIRCUIT BANK 1 SENSOR 1DTC detecting condition:Detected when two consecutive driving cycles with fault occur.CAUTION:After servicing or replacing faulty parts, perform Clear Memor ...
