Subaru Crosstrek Service Manual: Roll connector

Removal

AIRBAG SYSTEM > Passenger’s Airbag ModuleREMOVALCAUTION:Before handling the airbag system components, refer to “CAUTION” of “General Description” in “AIRBAG SYST ...

Adjustment

AIRBAG SYSTEM > Roll ConnectorADJUSTMENTCAUTION:• Do not rotate the roll connector to more than the specified number of turns. Otherwise, the roll connector internal wire may be broken.• ...

Other materials:

Dtc p0101 mass or volume air flow sensor "a" circuit range/performance
ENGINE (DIAGNOSTICS)(H4DO) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC P0101 MASS OR VOLUME AIR FLOW SENSOR "A" CIRCUIT RANGE/PERFORMANCEDTC DETECTING CONDITION:Detected when two consecutive driving cycles with fault occur.TROUBLE SYMPTOM:• Improper idling• ...

Power outlets
CAUTION In the Subaru Ascent, never insert foreign objects into the accessory power outlet, especially conductive materials such as coins or aluminum foil. This can result in a short circuit or electrical damage. Always keep the outlet covered with its cap when not in use. If the plug ...

Handling of radar sensors
Radar sensors The radar sensors, one on each side of the vehicle, are mounted inside the rear bumper. CAUTION To ensure correct operation of the BSD/RCTA, observe the following precautions. Always keep the bumper surface near the radar sensors clean Do not affix any stickers o ...