Subaru Crosstrek Service Manual: Replacement

Subaru Crosstrek Service Manual / Security and locks / Ignition key lock / Replacement

SECURITY AND LOCKS > Ignition Key Lock

REPLACEMENT

CAUTION:

• Before handling the airbag system components, refer to “CAUTION” of “General Description” in “AIRBAG SYSTEM”. General Description > CAUTION">

• If the steering wheel and steering angle sensor (steering roll connector) are removed, perform “VSC(VDC) Centering Mode” of the VDC. VDC Control Module and Hydraulic Control Unit (VDCCM&H/U) > ADJUSTMENT">

1. Disconnect the ground cable from battery and wait for at least 60 seconds before starting work. NOTE">

2. Remove the cover assembly - instrument panel LWR driver. Knee Airbag Module > REMOVAL">

3. Remove the knee airbag module. Knee Airbag Module > REMOVAL">

4. Remove the column assembly - steering. Steering Column > REMOVAL">

5. Remove the ignition key lock.

(1) Secure the column assembly - steering in a vise.

(2) Use the reverse tap and drill to remove the set bolt and remove the ignition key lock.

CAUTION:

Do not apply any impact to the set bolt by a chisel or punch.

6. Install the ignition key lock.

(1) Secure the ignition key lock to the column assembly - steering.

(2) Use new set bolts. Tighten the bolt until the bolt head is broken (bolt head wrenched off).

Disassembly

SECURITY AND LOCKS > Ignition Key LockDISASSEMBLY1. Remove the immobilizer antenna assembly or the ignition switch illumination. Immobilizer Antenna > REMOVAL">2. Release the claws, and ...

Inspection

SECURITY AND LOCKS > Ignition Key LockINSPECTIONPreparation tool:Circuit tester1. Check the resistance between switch terminals.Terminal No.Inspection conditionsStandardBetween all terminals(A)LOCK ...

Other materials:

Assembly
DRIVE SHAFT SYSTEM > Rear Hub Unit BearingASSEMBLY1. Install the rear hub unit bearing to the ST securely.Preparation tool:ST: HUB STAND (927080000)(1)Rear hub unit bearing2. Using a press, press new hub bolts (b) until their seating surfaces contact the rear hub unit bearing (a).NOTE:Use the 12 ...

Dtc b1813 short in driver s airbag dual stage - 2nd step circuit (to +b)
AIRBAG SYSTEM (DIAGNOSTICS) > Diagnostic Chart with Trouble CodeDTC B1813 SHORT IN DRIVER’S AIRBAG DUAL STAGE - 2ND STEP CIRCUIT (TO +B)Diagnosis start condition:Ignition voltage is 10 V to 16 V.DTC detecting condition:• Airbag main harness circuit is shorted to power supply.• A ...

Engine low oil level warning light
This light illuminates when the engine oil level decreases to the lower limit. If the engine low oil level warning light illuminates while driving, park the vehicle in a safe and level location, and then check the engine oil level. When the engine oil level is not within the normal rang ...