MANUAL TRANSMISSION AND DIFFERENTIAL(5MT) > Transmission Gear Oil
REPLACEMENT
1. Pull out the oil level gauge.
2. Lift up the vehicle.
3. Using the TORX® bit T70, remove the drain plug, and drain the gear oil completely.
CAUTION:
• Immediately after the vehicle has been running or after idling for a long time, the gear oil will be hot. Be careful not to receive burns.
• Be careful not to spill the gear oil on the exhaust pipe, to prevent emission of smoke or causing a fire. If gear oil is spilled, wipe it off completely.
4. Attach the drain plug using TORX® bit T70.
NOTE:
• Install the drain plug after draining gear oil.
• Use a new gasket.
Tightening torque:
44 N·m (4.5 kgf-m, 32.5 ft-lb) (aluminum gasket, silver)
70 N·m (7.1 kgf-m, 51.6 ft-lb) (copper gasket, brown)
70 N·m (7.1 kgf-m, 51.6 ft-lb) (metal gasket, black)
5. Lower the vehicle.
6. Pour gear oil through the oil level gauge hole.
CAUTION:
If an alternative gear oil is used, you may not have expected functionality and performance.
Recommended gear oil:
SUBARU GEAR OIL EXTRA MT
Alternative:
GL-5 (75W-90)
Gear oil capacity:
3.5 L (3.7 US qt, 3.1 Imp qt)
7. Check the gear oil amount, and confirm that it is within the specification.
Power door locking switches
Lock
Unlock
All doors and the rear gate can be locked
and unlocked by the power door locking
switches located at the driver's side and
the front passenger's side doors.
To lock the doors, push the front side of
the switch.
To unlock the doors, push the rear side of
the switch. ...
Installation
CONTINUOUSLY VARIABLE TRANSMISSION(TR580) > Forward Clutch AssemblyINSTALLATION1. Install the thrust bearing to the converter case.NOTE:Face the temper color surface to the converter case side.2. Install the seal ring to the input shaft.NOTE:• Use new seal rings.• When installing the ...
Basic diagnostic procedure Procedure
LAN SYSTEM (DIAGNOSTICS) > Basic Diagnostic ProcedurePROCEDURECAUTION:• Subaru Select Monitor is required for reading DTC, performing diagnosis, reading current data, customizing and active test (compulsory drive).• Remove foreign matter (dust, water, oil, etc.) from each control modu ...