Subaru Crosstrek Service Manual: Replacement

1. Disconnect the ground cable from battery.

2. Lift up the vehicle.

3. Clean the transmission exterior.

4. Using the TORX® bit T70, remove the drain plug, and drain the transmission gear oil completely.

CAUTION:

• Immediately after the vehicle has been running or after idling for a long time, the gear oil will be hot. Be careful not to receive burns.

• Be careful not to spill the gear oil on the exhaust pipe, to prevent emission of smoke or causing a fire. If gear oil is spilled, wipe it off completely.

5. Attach the drain plug using TORX® bit T70.

NOTE:

Use a new gasket.

Tightening torque:

44 N·m (4.5 kgf-m, 32.5 ft-lb) (aluminum gasket, silver)
70 N·m (7.1 kgf-m, 51.6 ft-lb) (copper gasket, brown)
70 N·m (7.1 kgf-m, 51.6 ft-lb) (metal gasket, black)

6. Remove the rear exhaust pipe. Rear Exhaust Pipe > REMOVAL">

7. Remove the center exhaust cover.

8. Remove the propeller shaft. Propeller Shaft > REMOVAL">

9. Using the ST, remove the oil seal.

10. Using the ST, install the oil seal.

NOTE:

• When grease is not applied to the oil seal lips, apply the transmission gear oil to the oil seal lips.

• Use a new oil seal.

11. Install the propeller shaft. Propeller Shaft > INSTALLATION">

12. Install the center exhaust cover.

Tightening torque:

18 N·m (1.8 kgf-m, 13.3 ft-lb)

13. Install the rear exhaust pipe. Rear Exhaust Pipe > INSTALLATION">

14. Lower the vehicle.

15. Pour in transmission gear oil and check the oil level. Transmission Gear Oil">

16. Connect the battery ground terminal.

Inspection

Reverse check sleeve

Other materials:

Installation
AIRBAG SYSTEM > Curtain Airbag ModuleINSTALLATIONCAUTION:• Before handling the airbag system components, refer to “CAUTION” of “General Description” in “AIRBAG SYSTEM”. General Description > CAUTION">• When installing the curtain airbag ...

Operation
TELEMATICS SYSTEM (DIAGNOSTICS) > System Operation Check ModeOPERATION1. On «Start» display, select «Diagnosis».2. On «Vehicle selection» display, input the target vehicle information and select «Confirmed».3. On «Main Menu» display, select «Each System».4. On «Select System» displa ...

Dtc u0155 lost communication with instrument panel cluster (ipc) control module
ENGINE (DIAGNOSTICS)(H4DO) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC U0155 LOST COMMUNICATION WITH INSTRUMENT PANEL CLUSTER (IPC) CONTROL MODULENOTE:For the diagnostic procedure, refer to LAN section. Basic Diagnostic Procedure">1. OUTLINE OF DIAGNOSISDetect malfunctio ...