Subaru Crosstrek Service Manual: Replacement

CAUTION:

If the engine oil is spilt over exhaust pipe or the under cover, wipe it off with cloth to avoid emitting smoke or causing a fire.

1. Turn the ignition switch to OFF.

2. Open the oil filler cap for quick draining of engine oil.

3. Lift up the vehicle.

4. Drain engine oil by loosening the drain plug.

NOTE:

Prepare the container for draining of engine oil.

5. After draining the engine oil, tighten the engine oil drain plug.

NOTE:

Use a new drain plug gasket.

Tightening torque:

41.7 N·m (4.3 kgf-m, 30.8 ft-lb)

6. Lower the vehicle.

7. Select engine oil of adequate quality and viscosity and fill it through the chain cover to the “F” line on the oil level gauge. Make sure that the vehicle is parked on a level surface when checking oil level.

Recommended oil:

Refer to “SPECIFICATION” for recommended oil. General Description > SPECIFICATION">

Engine oil capacity:

Refer to “SPECIFICATION” for engine oil capacity. General Description > SPECIFICATION">

8. Close the oil filler cap.

9. Start the engine to circulate the oil in engine.

10. Stop the engine (ignition OFF) and pull out the oil level gauge again, and check both sides of the oil level gauge. Use a lower side to check the engine oil level. If necessary, add engine oil up to the “F” line on oil level gauge.

Inspection

Engine oil filter

Other materials:

Component
BRAKE > General DescriptionCOMPONENT1. FRONT DISC BRAKE(A)Shim-separate brake pad type(B)Shim-integrated brake pad type (1)Caliper body(11)Pad clip - upper(19)Cap - bleeder(2)Bleeder - screw(12)Pad clip - lower (3)Guide pin - front brake (black)(13)Shim - disc brake front*1:17 mm (width a ...

Disassembly
CONTINUOUSLY VARIABLE TRANSMISSION(TR580) > Transfer ClutchDISASSEMBLY1. Remove the snap ring, and then remove the pressure plate, drive plate and driven plate.(A)Snap ring2. Compress the return spring using the ST to remove the snap ring.ST 18762AA001COMPRESSOR SPECIAL TOOL(A)Snap ring(B)Tran ...

Dtc p0757 shift solenoid "b" stuck on
CONTINUOUSLY VARIABLE TRANSMISSION (DIAGNOSTICS) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC P0757 SHIFT SOLENOID "B" STUCK ONDTC detecting condition:Detected when two consecutive driving cycles with fault occur.Trouble symptom:• Vibration occurs at shift change.& ...