DIFFERENTIALS > Rear Differential Side Oil Seal
REPLACEMENT
1. Remove the rear differential. Rear Differential (T-type) > REMOVAL"> Rear Differential (VA-type) > REMOVAL">
2. Remove the rear differential side oil seal using a ST or screwdriver wrapped with vinyl tape to prevent the side retainer from scratching.
ST 398527700 | PULLER ASSY |
3. Using the ST, install the oil seal.
CAUTION:
Pay attention to the left and right of the oil seal.
NOTE:
• Use a new oil seal.
• Apply differential gear oil to the oil seal lips.
• T-type
ST 398437700 | OIL SEAL INSTALLER |
• VA1-type
ST 498447100 | INSTALLER |
4. Install the rear differential. Rear Differential (T-type) > INSTALLATION"> Rear Differential (VA-type) > INSTALLATION">
Dtc c1212 front right abs sensor signal
VEHICLE DYNAMICS CONTROL (VDC) (DIAGNOSTICS) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC C1212 FRONT RIGHT ABS SENSOR SIGNALNOTE:For the diagnostic procedure, refer to “DTC C1242 REAR LEFT ABS SENSOR SIGNAL”. Diagnostic Procedure with Diagnostic Trouble Code (DTC) &g ...
Malfunction indicator light does not come on
ENGINE (DIAGNOSTICS)(H4DO) > Malfunction Indicator LightMALFUNCTION INDICATOR LIGHT DOES NOT COME ONTROUBLE SYMPTOM:When the ignition switch is turned to ON (engine OFF), malfunction indicator light does not illuminate.NOTE:Refer to IDI section for diagnostic procedure. Basic Diagnostic Procedur ...
Installation
MECHANICAL(H4DO) > Cylinder HeadINSTALLATION1. CYLINDER HEAD RH1. Clean the bolt holes in the cylinder block RH.CAUTION:To avoid erroneous tightening of the bolts, clean out the bolt holes sufficiently by blowing with compressed air to eliminate engine coolant etc.2. Apply liquid gasket to both s ...