DIFFERENTIALS > Differential Gear Oil
REPLACEMENT
CAUTION:
• Gear oil is extremely hot just after driving. Be wary of receiving burns.
• Be careful not to spill the differential gear oil on exhaust pipe. If gear oil is spilled, wipe it off completely.
1. Lift up the vehicle.
2. Remove the drain plug and filler plug, and drain the gear oil.
• T-type
(A) | Filler plug |
(B) | Drain plug |
• VA1-type
(A) | Filler plug |
(B) | Drain plug |
3. Install the drain plug.
NOTE:
• For the T-type, degrease the thread portion sufficiently and apply liquid gasket to the drain plug.
Liquid gasket:
THREE BOND 1105 (Part No. 004403010) or equivalent
• For VA1 type, use a new gasket.
Tightening torque:
T-type:
49 N·m (5.0 kgf-m, 36.1 ft-lb)
VA1-type:
50 N·m (5.1 kgf-m, 36.9 ft-lb)
4. Fill the differential carrier with gear oil to the bottom of filler plug.
NOTE:
Carefully refill gear oil while watching the level. Excessive or insufficient oil must be avoided.
Recommended gear oil:
General Description > SPECIFICATION">
Oil capacity:
0.8 L (0.8 US qt, 0.7 Imp qt)
• T-type
(A) | Filler plug |
(B) | Drain plug |
• VA1-type
(A) | Filler plug |
(B) | Drain plug |
5. Install the filler plug.
NOTE:
• For the T-type, degrease the thread portion sufficiently and apply liquid gasket to the filler plug.
Liquid gasket:
THREE BOND 1105 (Part No. 004403010) or equivalent
• For VA1 type, use a new gasket.
Tightening torque:
T-type:
49 N·m (5.0 kgf-m, 36.1 ft-lb)
VA1-type:
50 N·m (5.1 kgf-m, 36.9 ft-lb)
Coat hook
A coat hook is attached to the rear
passenger's hand grip.
WARNING
Obey the following instructions.
Do not hang coat hangers or
other hard or pointed objects on
the coat hooks. Hang clothing
directly on the coat hooks without
using hangers.
Before hanging clothing on the
coat ...
Inspection
CONTINUOUSLY VARIABLE TRANSMISSION(TR580) > Oil PumpINSPECTIONCheck the following items.• Check the oil pump for damage and wear.• Rotate the oil pump by hand, and check that it rotates smoothly.1. Measure the secondary pressure. Secondary Pressure (Line Pressure) Test > INSPECTIO ...
Dtc p013a o2 sensor slow response - rich to lean bank 1 sensor 2
ENGINE (DIAGNOSTICS)(H4DO) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC P013A O2 SENSOR SLOW RESPONSE - RICH TO LEAN BANK 1 SENSOR 2DTC detecting condition:Detected when two consecutive driving cycles with fault occur.CAUTION:After servicing or replacing faulty parts, perform Clea ...