CONTINUOUSLY VARIABLE TRANSMISSION(TR580) > Extension Case Oil Seal
REPLACEMENT
CAUTION:
Immediately after the vehicle has been running or after idling for a long time, the CVTF will be hot. Be careful not to burn yourself.
1. Lift up the vehicle.
2. Remove the center exhaust pipe. Center Exhaust Pipe > REMOVAL">
3. Remove the center exhaust cover.
4. Clean the transmission exterior.
5. Remove the propeller shaft. Propeller Shaft > REMOVAL">
6. Using a screwdriver or ST, remove the oil seal trying not to damage the extension case.
ST 398527700 | PULLER ASSY |
7. Using the ST, install the oil seal.
NOTE:
• Use a new oil seal.
• Apply CVTF to the oil seal lip and press-fitting surface.
ST 498057300 | OIL SEAL INSTALLER |
8. Install the propeller shaft. Propeller Shaft > INSTALLATION">
9. Install the center exhaust cover.
Tightening torque:
18 N·m (1.8 kgf-m, 13.3 ft-lb)
10. Install the center exhaust pipe. Center Exhaust Pipe > INSTALLATION">
11. Adjust the CVTF level and check there is no leakage. CVTF > ADJUSTMENT">
Top tether anchorages
Your vehicle is equipped with three top
tether anchorages so that a child restraint
system having a top tether can be
installed in the rear seat. When installing
a child restraint system using top tether,
proceed as follows, while observing the
instructions by the child restraint system
manuf ...
Dtc b1807 short in passenger s airbag (to ground)
AIRBAG SYSTEM (DIAGNOSTICS) > Diagnostic Chart with Trouble CodeDTC B1807 SHORT IN PASSENGER’S AIRBAG (TO GROUND)Diagnosis start condition:Ignition voltage is 10 V to 16 V.DTC detecting condition:• Airbag main harness circuit is shorted to ground.• Airbag module harness (passeng ...
List
INSTRUMENTATION/DRIVER INFO (DIAGNOSTICS) > Read Current DataLIST• Combination meter (models with normal meters)Items to be displayedUnit of measureContentNoteIG on trip numbertimesTime stamp information — IG on supply system — Time stamp information — past time after IG onmsTime stam ...