Subaru Crosstrek Service Manual: Replacement

CAUTION:

• Be careful not to spill the brake fluid. Brake fluid spilled on the vehicle body will harm the paint surface; wash it off with water and wipe clean quickly if spilled.

• Use new FMVSS No. 116 DOT3 or DOT4.

• Cover the air bleeder with cloth to prevent brake fluid from being splashed on surrounding parts when loosening the bleeder.

• Avoid mixing brake fluid of different brands to prevent fluid performance from degrading.

• Be careful not to allow dirt or dust to enter the reservoir tank.

• During the bleeding operation, keep the reservoir tank filled with brake fluid to prevent entry of air.

• Clutch pedal must be operated very slowly.

• Bleed air from the oil line with help of a co-worker.

• The required amount of brake fluid is approximately 150 mL (5.1 US fl oz, 5.3 Imp fl oz) for total clutch system.

1. Remove the clip (A) from the air intake boot.

2. Loosen the clamp (B) connecting the air intake boot and air cleaner case (rear).

3. Loosen the clamp (C) which connects the air intake boot and throttle body.

4. Remove the air intake boot from the throttle body, and move it to the left side wheel apron.

5. Drain the brake fluid from the air bleeder of the operating cylinder.

6. Refill the reservoir tank with recommended brake fluid.

Recommended brake fluid:

New FMVSS No. 116 DOT3 or DOT4

7. Bleed air from brake fluid. Clutch Fluid Air Bleeding">

8. Install the air intake boot. Air Intake Boot > INSTALLATION">

Inspection

Clutch pedal

Other materials:

Wiring diagram
SECURITY AND LOCKS > Push Button Start SystemWIRING DIAGRAMFor wiring diagrams related to the push button start system (ignition change), refer to the following items.• Keyless access system: Keyless Access System > WIRING DIAGRAM">• Push button start system: Push Button ...

MT models
1. Apply the parking brake. 2. Turn off unnecessary lights and accessories. 3. Depress the clutch pedal to the floor and shift the shift lever into neutral. Hold the clutch pedal to the floor while starting the engine. The starter motor will only operate when the clutch pedal is depress ...

Dtc p0604 internal control module random access memory (ram) error
ENGINE (DIAGNOSTICS)(H4DO) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC P0604 INTERNAL CONTROL MODULE RANDOM ACCESS MEMORY (RAM) ERRORDTC DETECTING CONDITION:Immediately at fault recognitionTROUBLE SYMPTOM:• Engine does not start• Engine stallCAUTION:After servicing or ...